MAX4104EUK+T
| Parameters | |
|---|---|
| Number of Circuits | 1 |
| Current - Supply | 20mA |
| Slew Rate | 400V/μs |
| Amplifier Type | Voltage Feedback |
| Common Mode Rejection Ratio | 95 dB |
| Current - Input Bias | 32μA |
| Voltage - Supply, Single/Dual (±) | ±3.5V~5.5V |
| Bandwidth | 625MHz |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Unity Gain BW-Nom | 625000 kHz |
| Average Bias Current-Max (IIB) | 70μA |
| Supply Voltage Limit-Max | 6V |
| Voltage - Input Offset | 1mV |
| Current - Output / Channel | 70mA |
| Neg Supply Voltage-Max (Vsup) | -6V |
| Length | 2.9mm |
| RoHS Status | ROHS3 Compliant |
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | SC-74A, SOT-753 |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C |
| Packaging | Tape & Reel (TR) |
| Published | 1998 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 5 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin (Sn) |
| Subcategory | Operational Amplifier |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.95mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX4104 |
| Pin Count | 5 |
| JESD-30 Code | R-PDSO-G5 |
| Qualification Status | Not Qualified |
MAX4104EUK+T Overview
Packaging for the buffer amplifier is in the form of a SC-74A, SOT-753 case. Buffer amps of this type are called Voltage Feedback-types. There is a Tape & Reel (TR) case that is delivered with the instrumentation amplifiers. A total of 5 terminations have been reported in the past few weeks. Buffer amplifier has a total of 5 pins on it. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. This particular linear amplifier is a type of Operational Amplifier device, to be precise. Surface Mount is the recommended mounting type of operational amplifiers. It is recommended that this op amp ic be operated at a temperature no higher than -40°C~85°C for optimal performance. The buffer amp consists of 1 circuits in total. We recommend that you use this electronic part with an 20mA supply in order to get the best performance from it.
MAX4104EUK+T Features
5 Pins
supply voltage of 5V
MAX4104EUK+T Applications
There are a lot of Maxim Integrated MAX4104EUK+T Instrumentational OP Amps applications.
- Video amplifiers
- E-book readers
- Video computer boards
- RF cable systems
- Medical instruments
- Proportional counter tubes
- Medical imaging
- pH (acidity)
- Industrial control system
- Video conversion and routing
