MAX410ESA+
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Surface Mount | YES |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C |
| Packaging | Tube |
| Published | 2003 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Operational Amplifiers |
| Technology | BIPOLAR |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX410 |
| Pin Count | 8 |
| Qualification Status | Not Qualified |
| Power Supplies | +-5V |
| Number of Circuits | 1 |
| Current - Supply | 2.5mA |
| Slew Rate | 4.5V/μs |
| Architecture | VOLTAGE-FEEDBACK |
| Amplifier Type | General Purpose |
| Common Mode Rejection Ratio | 120 dB |
| Current - Input Bias | 80nA |
| Voltage - Supply, Single/Dual (±) | 4.8V~10.5V ±2.4V~5.25V |
| Bandwidth | 28MHz |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Unity Gain BW-Nom | 28000 kHz |
| Average Bias Current-Max (IIB) | 0.35μA |
| Low-Offset | YES |
| Frequency Compensation | YES |
| Supply Voltage Limit-Max | 6V |
| Voltage - Input Offset | 120μV |
| Settling Time | 1.3 μs |
| Neg Supply Voltage-Max (Vsup) | -6V |
| Length | 4.9mm |
| RoHS Status | ROHS3 Compliant |
MAX410ESA+ Overview
A 8-SOIC (0.154, 3.90mm Width) case is used to package the op amp. This is a General Purpose type op amp. Instrumentation amplifier is delivered in a Tube case. We are approaching the 8h termination of the year. A total of 8 pins are located on this board. Please take in mind that this instrumentation amplifier should be run at 5V. I would like to specify that this buffer amplifier belongs to the Operational Amplifiers-type of devices. 8 pins are available on the instrumentation amplifier. This electronic part is recommended for mounting type Surface Mount. With regard to operating temperature, op amp ranges -40°C~85°C. A instrumentation amplifier like this has 1 circuits. It is recommended that this electronic component be used with an 2.5mA supply.
MAX410ESA+ Features
8 Pins
supply voltage of 5V
MAX410ESA+ Applications
There are a lot of Maxim Integrated MAX410ESA+ Instrumentational OP Amps applications.
- Broadcasting
- Ultrasound transducers
- MP3
- High/low-pass filter circuit
- Television
- Subtraction operation circuits
- Signal amplification
- Medical instruments
- Blood pressure sensors
- Automotive sensors
