MAX4172ESA-T
| Parameters | |
|---|---|
| Contact Plating | Tin |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Surface Mount | YES |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C |
| Packaging | Tape & Reel (TR) |
| Published | 1996 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Subcategory | Other Analog ICs |
| Max Power Dissipation | 471mW |
| Technology | BIPOLAR |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 12V |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Base Part Number | MAX4172 |
| Pin Count | 8 |
| Supply Voltage-Max (Vsup) | 32V |
| Supply Voltage-Min (Vsup) | 3V |
| Number of Channels | 1 |
| Analog IC - Other Type | POWER SUPPLY SUPPORT CIRCUIT |
| Operating Supply Current | 800μA |
| Nominal Supply Current | 800μA |
| Adjustable Threshold | NO |
| Amplifier Type | Current Sense |
| Current - Input Bias | 50μA |
| Voltage - Supply, Single/Dual (±) | 3V~32V |
| Output Current per Channel | 1.75mA |
| Input Offset Voltage (Vos) | 1mV |
| Bandwidth | 800 kHz |
| Voltage - Input Offset | 1mV |
| Length | 4.9mm |
| Radiation Hardening | No |
| REACH SVHC | Unknown |
| RoHS Status | ROHS3 Compliant |
MAX4172ESA-T Overview
The linear amplifier is packaged in a 8-SOIC (0.154, 3.90mm Width) case which makes it easy for the consumer to handle. An op amp ic of the Current Sense type. A Tape & Reel (TR) case is used to deliver the buffer op amp. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. The linear amplifier should be run at 12V at all times, so please keep that in mind when using it. In more specific terms, this linear amplifier can be categoriOther Analog ICsed as a Other Analog ICs-type device. There are 8 pins on this chip. Regarding input offset voltage, buffer amplifier rates 1mV voltage. The mounting type that is recommended for this electrical part is Surface Mount. It is important to note that this linear amplifier works well at a temperature of -40°C~85°C when it comes to operating temperatureAn 800μA volt supply current is needed for this linear amplifier to operate. There are 1 channels on the operational amplifiers. This linear amplifier also utiliPOWER SUPPLY SUPPORT CIRCUITes an analog IC known as a POWER SUPPLY SUPPORT CIRCUIT.
MAX4172ESA-T Features
8 Pins
supply voltage of 12V
MAX4172ESA-T Applications
There are a lot of Maxim Integrated MAX4172ESA-T Instrumentational OP Amps applications.
- Oscilloscopes
- RF cable systems
- Measurements of Wheatstone bridge
- Band-pass filter
- Radiation thermometry transducers
- Ultrasound transducers
- Home audio systems
- Weighing systems
- Tablets
- Addition operation circuits
