MAX4173TESA+T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C |
| Packaging | Tape & Reel (TR) |
| Published | 2011 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Other Analog ICs |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 12V |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX4173 |
| Pin Count | 8 |
| JESD-30 Code | R-PDSO-G8 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 28V |
| Power Supplies | 3/28V |
| Supply Voltage-Min (Vsup) | 3V |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| Analog IC - Other Type | POWER SUPPLY SUPPORT CIRCUIT |
| Adjustable Threshold | NO |
| Current - Supply | 420μA |
| Amplifier Type | Current Sense |
| Current - Input Bias | 700μA |
| Voltage - Supply, Single/Dual (±) | 3V~28V |
| Voltage - Input Offset | 300μV |
| -3db Bandwidth | 1.7MHz |
| Length | 4.9mm |
| RoHS Status | ROHS3 Compliant |
MAX4173TESA+T Overview
In order to protect the op amps, a 8-SOIC (0.154, 3.90mm Width) case is used. A Current Sense-type buffer amplifier is shown here. Linear amplifier is delivered in a Tape & Reel (TR) case. In recent months, the number of terminations has approached 8. Linear amplifier has a total of 8 pins. Please take in mind that this instrumentation amplifier should be run at 12V. It should be noted that this op amp is a type of Other Analog ICs device. This electronic component is recommended to be mounted using the mounting type Surface Mount. The buffer amplifier functions well at -40°C~85°C as far as operating temperature is concerned. On this buffer amplifier, there are 1 circuits. As far as the device is concerned, buffer amplifier has 1 channels. A supply of 420μA or higher is recommended for use with this electronic part. An analog IC known as a POWER SUPPLY SUPPORT CIRCUIT is the other type of IC that is used in this op amp ic.
MAX4173TESA+T Features
8 Pins
supply voltage of 12V
MAX4173TESA+T Applications
There are a lot of Maxim Integrated MAX4173TESA+T Instrumentational OP Amps applications.
- Proportional operation circuits
- Home audio systems
- Subtraction operation circuits
- Car stereo
- Measurements of Wheatstone bridge
- Oscilloscopes
- Signal amplification
- RF cable systems
- Communication
- Weighing systems
