MAX4213EUA+
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) |
| Surface Mount | YES |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C |
| Packaging | Tube |
| Published | 2001 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Operational Amplifier |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX4213 |
| Pin Count | 8 |
| Qualification Status | Not Qualified |
| Output Type | Rail-to-Rail |
| Number of Circuits | 1 |
| Current - Supply | 5.5mA |
| Slew Rate | 600V/μs |
| Amplifier Type | Voltage Feedback |
| Current - Input Bias | 5.4μA |
| Voltage - Supply, Single/Dual (±) | 3.15V~11V ±1.575V~5.5V |
| Bandwidth | 300MHz |
| Voltage - Input Offset | 4mV |
| Length | 3mm |
| RoHS Status | ROHS3 Compliant |
MAX4213EUA+ Overview
A 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) case is used to package the op amp. There are two types of operational amplifiers in this circuit. Instrumentation amplifier is delivered in a Tube case. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. A type of Operational Amplifier op amp ic can be identified by the fact that this is a type of Operational Amplifier device. There are 8 pins on this chip. It is recommended that this electronic component be mounted using the Surface Mount mounting type. According to the manufacturer, this buffer op amp works well at -40°C~85°C , which is a good operating temperature. A instrumentation amplifier like this has 1 circuits. One of its many advantages is that buffer op amp outputs Rail-to-Rail signals. We recommend that you use this electronic part with an 5.5mA supply in order to get the best performance from it.
MAX4213EUA+ Features
8 Pins
Output Type: Rail-to-Rail
MAX4213EUA+ Applications
There are a lot of Maxim Integrated MAX4213EUA+ Instrumentational OP Amps applications.
- Weighing systems
- Integrator circuits
- Hand-held batteries
- Non-polarized electrodes
- Navigation
- Comparator
- High/low-pass filter circuit
- Large motor controllers
- Biopotential
- Signal transformation
