MAX4224EUT+T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | SOT-23-6 |
| Surface Mount | YES |
| Number of Pins | 6 |
| Operating Temperature | -40°C~85°C |
| Packaging | Tape & Reel (TR) |
| Published | 1998 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin (Sn) |
| Subcategory | Operational Amplifier |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.95mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX4224 |
| Pin Count | 6 |
| Qualification Status | Not Qualified |
| Number of Circuits | 1 |
| Output Current | 80mA |
| Current - Supply | 6mA |
| Slew Rate | 1700V/μs |
| Amplifier Type | Current Feedback |
| Common Mode Rejection Ratio | 61 dB |
| Current - Input Bias | 4μA |
| Voltage - Supply, Single/Dual (±) | ±2.85V~5.5V |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Unity Gain BW-Nom | 330000 kHz |
| Voltage - Input Offset | 500μV |
| -3db Bandwidth | 600MHz |
| Length | 2.9mm |
| RoHS Status | ROHS3 Compliant |
MAX4224EUT+T Overview
In the package, you will find a SOT-23-6-case to contain the op amp ic. Buffer amps of this type are called Current Feedback-types. A Tape & Reel (TR) case is used for delivering the op amp. It is estimated that there will be 6 terminations in the next few months. The pins on this board total to 6 in total. It is important to remember that this op amp should be operated at a voltage of 5V volts. In more specific terms, this linear amplifier can be categoriOperational Amplifiered as a Operational Amplifier-type device. 6 pins are included on the operational amplifiers. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. In terms of operating temperature, this instrumentation amplifier performs well at a temperature of about -40°C~85°C . During the manufacturing process, this buffer amplifier is divided into 1 circuits. As a result, it is recommended that a power supply of 6mA be used with this electronic part.
MAX4224EUT+T Features
6 Pins
supply voltage of 5V
MAX4224EUT+T Applications
There are a lot of Maxim Integrated MAX4224EUT+T Instrumentational OP Amps applications.
- Measurements of Wheatstone bridge
- Switching amplifier
- Strain gauges
- Hand-held batteries
- Signal transformation
- Information processing
- Logarithmic operation circuits
- Fast A/D and D/A converters
- Portable electronic products powered by batteries
- Band-stop filter
