MAX4377FASA+
| Parameters | |
|---|---|
| Current - Input Bias | 800μA |
| Voltage - Supply, Single/Dual (±) | 3V~28V |
| Bandwidth | 1.7MHz |
| Supply Voltage Limit-Max | 30V |
| Height Seated (Max) | 1.75mm |
| Length | 4.9mm |
| RoHS Status | ROHS3 Compliant |
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Surface Mount | YES |
| Number of Pins | 8 |
| Operating Temperature | -40°C~125°C |
| Packaging | Tube |
| Published | 2012 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Operational Amplifier |
| Technology | BICMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 12V |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX4377 |
| Pin Count | 8 |
| Qualification Status | Not Qualified |
| Number of Circuits | 2 |
| Current - Supply | 1mA |
| Slew Rate | 10V/μs |
| Amplifier Type | Current Sense |
| Common Mode Rejection Ratio | 90 dB |
MAX4377FASA+ Overview
There is a 8-SOIC (0.154, 3.90mm Width) case package that contains the instrumentation amplifiers. Op amps are Current Sense types of amplifier on the chip. There is a Tube case that is delivered with the instrumentation amplifiers. It is estimated that there will be 8 terminations in the next few months. A total of 8 pins are located on this board. It is important to remember that this op amp should be operated at a voltage of 12V volts. To be specific, this instrumentation amplifier is a type of Operational Amplifier. There are 8 pins on this chip. For this electrical component, Surface Mount is the recommended mounting type. In relation to the operating temperature of this buffer op amp, it works well at an average of -40°C~125°C . In total, there are 2 circuits on this buffer amplifier. This electronic part is recommended to be used with an 1mA supply for best performance.
MAX4377FASA+ Features
8 Pins
supply voltage of 12V
MAX4377FASA+ Applications
There are a lot of Maxim Integrated MAX4377FASA+ Instrumentational OP Amps applications.
- Non-polarized electrodes
- Inverse/same-phase proportional circuit
- Communication
- Video amplifiers
- Proportional counter tubes
- Tablets
- Division circuits
- Signal transformation
- Radar
- Wireless base stations
