Parameters |
Factory Lead Time |
1 Week |
Lifecycle Status |
PRODUCTION (Last Updated: 1 month ago) |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
14-SOIC (0.154, 3.90mm Width) |
Number of Pins |
14 |
Operating Temperature |
-40°C~125°C |
Packaging |
Tape & Reel (TR) |
Published |
2013 |
Pbfree Code |
yes |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
14 |
ECCN Code |
EAR99 |
Subcategory |
Operational Amplifier |
Technology |
BICMOS |
Terminal Position |
DUAL |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
NOT SPECIFIED |
Number of Functions |
4 |
Supply Voltage |
10V |
Terminal Pitch |
1.27mm |
Time@Peak Reflow Temperature-Max (s) |
NOT SPECIFIED |
Base Part Number |
MAX44245 |
Output Type |
Rail-to-Rail |
Number of Circuits |
4 |
Operating Supply Current |
90μA |
Slew Rate |
0.7V/μs |
Amplifier Type |
General Purpose |
Common Mode Rejection Ratio |
130 dB |
Current - Input Bias |
150pA |
Voltage - Supply, Single/Dual (±) |
2.7V~36V ±1.35V~18V |
Output Current per Channel |
40mA |
Input Offset Voltage (Vos) |
2μV |
Gain Bandwidth Product |
1MHz |
Unity Gain BW-Nom |
1000 kHz |
Voltage Gain |
150dB |
Average Bias Current-Max (IIB) |
0.0007μA |
Height Seated (Max) |
1.75mm |
Length |
8.65mm |
RoHS Status |
ROHS3 Compliant |
MAX44245ASD+T Overview
There is a 14-SOIC (0.154, 3.90mm Width) case package that contains the instrumentation amplifiers. A General Purpose-type buffer amplifier is shown here. Instrumentation amplifier is delivered in a Tape & Reel (TR) case. It is estimated that there will be 14 terminations in the next few months. It would be helpful if you could remember that this op amp ic should be powered by an 10V battery. There are two types of Operational Amplifier op amps in this case, and this device falls into one of them. In total, the buffer amplifier consists of 14 pins. In terms of input offset voltage, operational amplifier rates 2μV. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. According to the manufacturer, this buffer op amp works well at -40°C~125°C , which is a good operating temperature. It is possible to operate this buffer amplifier from a supply current of 90μA . 150dB should remain the voltage gain. There are 4 circuits on op amps. On the output type, there are Rail-to-Rail different types of op amps.
MAX44245ASD+T Features
supply voltage of 10V
150dB voltage gain
Output Type: Rail-to-Rail
MAX44245ASD+T Applications
There are a lot of Maxim Integrated MAX44245ASD+T Instrumentational OP Amps applications.
- Computer workstations
- Polarized electrodes
- RF cable systems
- Weak signal detection
- Multimedia playback equipment
- Semiconductor detectors
- Band-pass filter
- Exponential operation circuits
- Displayers for aircraft and air transportation control systems
- Portable electronic products powered by batteries