MAX4431ESA+
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C |
| Packaging | Tube |
| Published | 2000 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX4431 |
| Pin Count | 8 |
| Operating Supply Voltage | 5.5V |
| Number of Circuits | 1 |
| Operating Supply Current | 11mA |
| Nominal Supply Current | 11mA |
| Output Current | 60mA |
| Slew Rate | 145V/μs |
| Amplifier Type | Voltage Feedback |
| Common Mode Rejection Ratio | 100 dB |
| Current - Input Bias | 11μA |
| Voltage - Supply, Single/Dual (±) | 9V~11V ±4.5V~5.5V |
| Output Current per Channel | 60mA |
| Input Offset Voltage (Vos) | 1.25mV |
| Bandwidth | 215MHz |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Unity Gain BW-Nom | 215000 kHz |
| Voltage Gain | 125dB |
| Average Bias Current-Max (IIB) | 30μA |
| Supply Voltage Limit-Max | 6V |
| Length | 4.9mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
MAX4431ESA+ Overview
In the package, you will find a 8-SOIC (0.154, 3.90mm Width)-case to contain the op amp ic. Voltage Feedback-type instrumentation amplifiers are used in this application. As far as the packaging is concerned, buffer op amp is delivered in a Tube case. A total of 8 terminations have been reported in the past few weeks. A total of 8 pins are located on this board. The linear amplifier should be run at 5V at all times, so please keep that in mind when using it. Linear amplifier includes 8 pins. In terms of input offset voltage, operational amplifier rates 1.25mV. It is recommended that this electronic component be mounted using the Surface Mount mounting type. It is recommended that this op amp ic be operated at a temperature no higher than -40°C~85°C for optimal performance. The buffer amplifier is capable of operating from a supply current of 11mA . Voltage gain should remain at 125dB. On this instrumentation amplifier, there are 1 circuits that are connected together. The operating supply voltage of the buffer op amp is rated at 5.5V.
MAX4431ESA+ Features
8 Pins
supply voltage of 5V
125dB voltage gain
MAX4431ESA+ Applications
There are a lot of Maxim Integrated MAX4431ESA+ Instrumentational OP Amps applications.
- Weak signal detection
- MP3
- High-frequency data acquisition systems
- Professional videography
- Fission chambers
- Automation control systems
- Micro signal measurement
- Active probe
- Tablets
- Signal amplification
