MAX4502EPA
| Parameters | |
|---|---|
| Mounting Type | Through Hole |
| Package / Case | 8-DIP (0.300, 7.62mm) |
| Surface Mount | NO |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| Terminal Finish | TIN LEAD |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 2.54mm |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Pin Count | 8 |
| JESD-30 Code | R-PDIP-T8 |
| Supply Voltage-Max (Vsup) | 5.5V |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| On-State Resistance (Max) | 250Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 100 dB |
| Current - Leakage (IS(off)) (Max) | 1nA |
| Channel Capacitance (CS(off), CD(off)) | 3pF 3pF |
| Switch Circuit | SPST - NC |
| Switch Time (Ton, Toff) (Max) | 75ns, 50ns |
| Charge Injection | 1pC |
| Switch-on Time-Max | 75ns |
| Switch-off Time-Max | 50ns |
| Voltage - Supply, Single (V+) | 2V~12V |
| Height Seated (Max) | 4.572mm |
| Length | 9.375mm |
| Width | 7.62mm |
| RoHS Status | Non-RoHS Compliant |
MAX4502EPA Overview
Shipping overseas is convenient with the electronic component packed in 8-DIP (0.300, 7.62mm). The advanced packaging method Tube provides high reliability. It is mounted in the position Through Hole. Multiplexers and demultiplexers have a number of circuits 1:1. Increasing operating temperature to around -40°C~85°C TA. 8 terminations have been made so far. This electronic part offers high-quality output due to its 1 channels. When a voltage supply of 5V is used, the electronic component should be turned on and run. An electrical component of this type can be found in the 8 series. These analog multiplexers are built based on SPST - NC switching circuits. A total of 1 circuits make up this switch device. A voltage of 2V~12V is required for this switch device, which drains from a single voltage source.
MAX4502EPA Features
1 Channels
Switch Circuit: SPST - NC
MAX4502EPA Applications
There are a lot of Rochester Electronics, LLC MAX4502EPA Analog Switches & Multiplexers ICs applications.
- Battery Powered Systems
- Fiber In The Loop (FITL)
- Residential Gateways, Home Gateway/Router
- SDH/SONET multiplexers
- Modems
- 65 V DACs
- Multiplexers
- Audio and video signal routing
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- HDTV
