MAX4514CSA
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Surface Mount | YES |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Published | 1997 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Base Part Number | MAX4514 |
| Pin Count | 8 |
| JESD-30 Code | R-PDSO-G8 |
| Qualification Status | Not Qualified |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| On-State Resistance (Max) | 20Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 90 dB |
| Current - Leakage (IS(off)) (Max) | 1nA |
| Channel Capacitance (CS(off), CD(off)) | 14pF 14pF |
| On-state Resistance Match-Nom | 1Ohm |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 150ns, 100ns |
| Charge Injection | 2pC |
| Switching | BREAK-BEFORE-MAKE |
| Voltage - Supply, Single (V+) | 2V~12V |
| Normal Position | NO |
| Length | 4.9mm |
| Width | 3.9mm |
| RoHS Status | Non-RoHS Compliant |
MAX4514CSA Overview
Shipping overseas is convenient due to the electrical component's packing in 8-SOIC (0.154, 3.90mm Width). High reliability is provided by advanced packaging method Tube. A switch device like this is mounted in Surface Mount. 1:1 is the ratio between multiplexers and demultiplexers. The operating temperature is extended to around 0°C~70°C TA. Total terminations are 8. By its 1 channels, the electronic component provides high-quality output. When the electronic component is given a voltage of 5V, it should be turned on and run. A total of 8 pins are injected into the body of the electronic part. SPST - NO switching circuits are used in these analog switch ics. There are 1 circuits in this multiplexer. Try searching for the analog switch ic with MAX4514 if you are looking for variants. Theswitch device is a typical Multiplexer or Switches. The voltage required by this switch device is 2V~12V, draining from a single voltage supply.
MAX4514CSA Features
1 Channels
Switch Circuit: SPST - NO
MAX4514CSA Applications
There are a lot of Maxim Integrated MAX4514CSA Analog Switches & Multiplexers ICs applications.
- Industrial and process control systems
- Fiber to the Home
- Residential Gateways, Home Gateway/Router
- DVD-R
- Cable Modem
- Low-Voltage
- Microprocessor controlled systems
- Signal routing between systems
- Ultrasound
- Communications systems
