MAX4523CSE+

80ns, 30ns SPST - NO/NC 100Ohm Analog Switches BREAK-BEFORE-MAKE MAX4523 16 Pins 1nA 5V 16-SOIC (0.154, 3.90mm Width)

Manufacturer: Maxim Integrated
Nocochips NO: 503-MAX4523CSE+
Package: 16-SOIC (0.154, 3.90mm Width)
Datasheet: PDF
Stock: 940
Description: 80ns, 30ns SPST - NO/NC 100Ohm Analog Switches BREAK-BEFORE-MAKE MAX4523 16 Pins 1nA 5V 16-SOIC (0.154, 3.90mm Width)(Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	16-SOIC (0.154, 3.90mm Width)
Number of Pins	16
Operating Temperature	0°C~70°C TA
Packaging	Tube
Published	2005
JESD-609 Code	e3
Pbfree Code	yes
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	16
ECCN Code	EAR99
Resistance	100Ohm
Terminal Finish	Tin (Sn)
Subcategory	Multiplexer or Switches
Max Power Dissipation	696mW
Technology	CMOS
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	4
Supply Voltage	5V
Terminal Pitch	1.27mm
Base Part Number	MAX4523
Output	SEPARATE OUTPUT
Pin Count	16
Operating Supply Voltage	6V
Number of Channels	1
Number of Circuits	4
Max Supply Voltage	12V
Min Supply Voltage	2V
Operating Supply Current	1μA
Nominal Supply Current	1μA
Max Supply Current	1μA
Throw Configuration	SPST
Turn On Delay Time	80 ns
Voltage - Supply, Single/Dual (±)	2V~12V ±2V~6V
Supply Type	Dual, Single
Neg Supply Voltage-Nom (Vsup)	-5V
Turn-Off Delay Time	250 ns
Max Dual Supply Voltage	6V
On-State Resistance (Max)	100Ohm
Min Dual Supply Voltage	2V
Dual Supply Voltage	5V
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	90 dB
Current - Leakage (IS(off)) (Max)	1nA
Channel Capacitance (CS(off), CD(off))	2pF 2pF
On-state Resistance Match-Nom	4Ohm
Switch Circuit	SPST - NO/NC
Switch Time (Ton, Toff) (Max)	80ns, 30ns
Charge Injection	1pC
Channel-to-Channel Matching (ΔRon)	1 Ω
Crosstalk	-90dB @ 100kHz
Switching	BREAK-BEFORE-MAKE
Switch-off Time-Max	30ns
Height	1.5mm
Length	10mm
Width	4mm
Radiation Hardening	No
REACH SVHC	Unknown
RoHS Status	ROHS3 Compliant

MAX4523CSE+ Overview

Packed in 16-SOIC (0.154, 3.90mm Width), the electronic component is convenient for shipping overseas. The advanced packaging method Tube provides high reliability. This analog switch is mounted in Surface Mount. Multiplexers and demultiplexers have a number of circuits 1:1. Operation at a temperature around 0°C~70°C TA. The total number of terminations is 16. A electrical component with 1 channels is capable of high-quality output. In the case of a voltage supply of 5V volts, the electrical part can be powered up and run. There are 16 pins injected into the electronic part body. Circuits based on SPST - NO/NC switching are used to construct these analog switch ics. This multiplexer is composed of 4 circuits. Try searching for MAX4523 variants of the analog switch ic. Analog switches have 100Ohm internal resistance. For details about the functions of 16 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 12V. Dual, Single supply type digital switch with a low cost. There should be 2V voltage fed to the electrical part below 2V. The analogue multiplexer could operate on 1μA current. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 6V. For dual power supplies, a voltage of at least 2V should be attached. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. 6V operating voltages can be used with this electrical part.