Parameters |
Switch Time (Ton, Toff) (Max) |
80ns, 30ns |
Charge Injection |
1pC |
Channel-to-Channel Matching (ΔRon) |
1 Ω |
Crosstalk |
-90dB @ 100kHz |
Switching |
BREAK-BEFORE-MAKE |
Switch-off Time-Max |
30ns |
Height Seated (Max) |
1.75mm |
Length |
9.9mm |
Width |
3.9mm |
Radiation Hardening |
No |
REACH SVHC |
Unknown |
RoHS Status |
Non-RoHS Compliant |
Lead Free |
Contains Lead |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
16-SOIC (0.154, 3.90mm Width) |
Number of Pins |
16 |
Operating Temperature |
-40°C~85°C TA |
Packaging |
Tube |
Published |
2007 |
JESD-609 Code |
e0 |
Pbfree Code |
no |
Part Status |
Obsolete |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
16 |
ECCN Code |
EAR99 |
Resistance |
100Ohm |
Terminal Finish |
Tin/Lead (Sn85Pb15) |
Additional Feature |
ALSO OPERATE WITH 2V TO 12V SINGLE SUPPLY |
Subcategory |
Multiplexer or Switches |
Max Power Dissipation |
696mW |
Technology |
CMOS |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
240 |
Number of Functions |
4 |
Supply Voltage |
5V |
Terminal Pitch |
1.27mm |
Time@Peak Reflow Temperature-Max (s) |
20 |
Base Part Number |
MAX4523 |
Output |
SEPARATE OUTPUT |
Pin Count |
16 |
Operating Supply Voltage |
6V |
Power Supplies |
3/5/+-5V |
Number of Channels |
4 |
Max Supply Voltage |
12V |
Min Supply Voltage |
2V |
Operating Supply Current |
1μA |
Nominal Supply Current |
1μA |
Max Supply Current |
1μA |
Throw Configuration |
SPST |
Turn On Delay Time |
80 ns |
Voltage - Supply, Single/Dual (±) |
2V~12V ±2V~6V |
Supply Type |
Dual, Single |
Neg Supply Voltage-Nom (Vsup) |
-5V |
Turn-Off Delay Time |
250 ns |
Max Dual Supply Voltage |
6V |
On-State Resistance (Max) |
100Ohm |
Min Dual Supply Voltage |
2V |
Multiplexer/Demultiplexer Circuit |
1:1 |
Off-state Isolation-Nom |
90 dB |
Current - Leakage (IS(off)) (Max) |
1nA |
Channel Capacitance (CS(off), CD(off)) |
2pF 2pF |
On-state Resistance Match-Nom |
1Ohm |
Switch Circuit |
SPST - NO/NC |
MAX4523ESE Overview
Shipping overseas is convenient due to the electrical component's packing in 16-SOIC (0.154, 3.90mm Width). Advanced packaging method Tube is used to provide high reliability. There is an analog multiplexer mounted in position Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. Operating temperature extended to -40°C~85°C TA. Total terminations are 16. A electrical component with 4 channels is capable of high-quality output. Powered by a 5V voltage supply, the electrical part should be switched on and run. A total of 16 pins are injected into the body of the electronic part. Circuits based on SPST - NO/NC switching are used to construct these analog switch ics. Try searching for the analog switch ic with MAX4523 if you are looking for variants. In this multiplexer, the internal resistance is 100Ohm. To find out what the functions of 16 pins are, please refer to their datasheets. The analogue multiplexer in this example is a typical Multiplexer or Switches. Users should never supply a voltage higher than 12V to a switch device. The digital multiplexer has a low cost Dual, Single supply. 2V is the lowest voltage that should be fed to the electronic electronic part. For this multiplexer to operate, 1μA current would be sufficient. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. For this multiplexer, dual supply voltage is feasible, but it should not exceed 6V. The voltage should be at least 2V if you are using dual power supplies. In this switch multiplexer, there are SEPARATE OUTPUT outputs available. 6V operating voltages are supported by the electronic component. Additional features include: ALSO OPERATE WITH 2V TO 12V SINGLE SUPPLY.
MAX4523ESE Features
4 Channels
Switch Circuit: SPST - NO/NC
1μA Supply Current
Additional Features: ALSO OPERATE WITH 2V TO 12V SINGLE SUPPLY
MAX4523ESE Applications
There are a lot of Maxim Integrated MAX4523ESE Analog Switches & Multiplexers ICs applications.
- Sample-and-hold systems
- Fault Tolerant Systems
- CSU
- E1 Multiplexer
- Data Acquisition Systems
- Residential Gateways, Home Gateway/Router
- Battery-powered systems
- PDAs
- Low-Voltage
- Audio and video switching