MAX4538ESE

100ns, 50ns SPST - NO/NC 100Ohm Analog Switches BREAK-BEFORE-MAKE MAX4538 16 Pins 2nA 5V 16-SOIC (0.154, 3.90mm Width)

Manufacturer: Maxim Integrated
Nocochips NO: 503-MAX4538ESE
Package: 16-SOIC (0.154, 3.90mm Width)
Datasheet: PDF
Stock: 129
Description: 100ns, 50ns SPST - NO/NC 100Ohm Analog Switches BREAK-BEFORE-MAKE MAX4538 16 Pins 2nA 5V 16-SOIC (0.154, 3.90mm Width)(Kg)

Details

Tags

Parameters
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	16-SOIC (0.154, 3.90mm Width)
Number of Pins	16
Operating Temperature	-40°C~85°C TA
Packaging	Tube
Published	1996
JESD-609 Code	e0
Pbfree Code	no
Part Status	Obsolete
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	16
ECCN Code	EAR99
Resistance	100Ohm
Terminal Finish	Tin/Lead (Sn85Pb15)
Subcategory	Multiplexer or Switches
Max Power Dissipation	696mW
Technology	CMOS
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	240
Number of Functions	4
Supply Voltage	5V
Terminal Pitch	1.27mm
Time@Peak Reflow Temperature-Max (s)	20
Base Part Number	MAX4538
Output	SEPARATE OUTPUT
Pin Count	16
Power Supplies	3/+-5V
Number of Channels	1
Number of Circuits	4
Max Supply Voltage	6V
Min Supply Voltage	2V
Operating Supply Current	50nA
Nominal Supply Current	50nA
Max Supply Current	1μA
Throw Configuration	SPST
Turn On Delay Time	100 ns
Voltage - Supply, Single/Dual (±)	2V~12V ±2V~6V
Supply Type	Dual, Single
Neg Supply Voltage-Nom (Vsup)	-5V
Turn-Off Delay Time	50 ns
Max Dual Supply Voltage	6V
On-State Resistance (Max)	100Ohm
Min Dual Supply Voltage	2V
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	65 dB
Current - Leakage (IS(off)) (Max)	2nA
Channel Capacitance (CS(off), CD(off))	2pF 2pF
On-state Resistance Match-Nom	4Ohm
Switch Circuit	SPST - NO/NC
Switch Time (Ton, Toff) (Max)	100ns, 50ns
Charge Injection	1pC
Channel-to-Channel Matching (ΔRon)	1 Ω
Crosstalk	-75dB @ 1MHz
Switching	BREAK-BEFORE-MAKE
Height Seated (Max)	1.75mm
Length	9.9mm
Width	3.9mm
Radiation Hardening	No
RoHS Status	Non-RoHS Compliant

MAX4538ESE Overview

The electrical component comes in 16-SOIC (0.154, 3.90mm Width) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tube is used. In Surface Mount, this analog switch is mounted. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operational temperature extended around -40°C~85°C TA. In total, there have been 16 terminations. The electronic part delivers high-quality output through its 1 channels. An 5V voltage supply should allow the electrical part to be turned on and run. There is an electrical component included in the 16 series. A SPST - NO/NC switching circuit is used for these analog switches. The multiplexer consists of 4 circuits. Try searching for the analog switch ic with MAX4538 if you are looking for variants. It has an internal resistance of 100Ohm. Datasheets for functions of 16 pins are available. The analog multiplexer shown here is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 6V. The digital multiplexer has a low cost Dual, Single supply. There should be 2V voltage fed to the electrical part below 2V. 50nA current would be enough for this multiplexer to operate. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. If put voltage greater than 6V on the multiplexer, damage may be caused to the device. In the case of dual power supplies, you should connect at least 2V. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer.