MAX4541ETA+T

100ns, 75ns SPST - NO 60Ohm DUAL Analog Switches MAX4541 5V 8-WDFN Exposed Pad

Manufacturer: Maxim Integrated
Nocochips NO: 503-MAX4541ETA+T
Package: 8-WDFN Exposed Pad
Datasheet: PDF
Stock: 443
Description: 100ns, 75ns SPST - NO 60Ohm DUAL Analog Switches MAX4541 5V 8-WDFN Exposed Pad(Kg)

Details

Tags

Parameters
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	8-WDFN Exposed Pad
Number of Pins	8
Operating Temperature	-40°C~85°C TA
Packaging	Tape & Reel (TR)
Published	2007
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	8
Resistance	60Ohm
Max Power Dissipation	471mW
Technology	CMOS
Terminal Position	DUAL
Number of Functions	1
Supply Voltage	5V
Terminal Pitch	0.65mm
Base Part Number	MAX4541
Number of Channels	2
Number of Circuits	2
Max Supply Voltage	12V
Min Supply Voltage	2.7V
Operating Supply Current	100pA
Nominal Supply Current	1μA
Throw Configuration	SPST
Turn On Delay Time	125 ns
Supply Type	Single
Turn-Off Delay Time	400 ns
On-State Resistance (Max)	60Ohm
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	76 dB
Channel Capacitance (CS(off), CD(off))	8pF 8pF
On-state Resistance Match-Nom	2Ohm
Switch Circuit	SPST - NO
Switch Time (Ton, Toff) (Max)	100ns, 75ns
Charge Injection	1pC
Channel-to-Channel Matching (ΔRon)	800m Ω
Crosstalk	-90dB @ 1MHz
Switch-off Time-Max	150ns
Voltage - Supply, Single (V+)	2.7V~12V
Length	3mm
Width	3mm
Radiation Hardening	No
RoHS Status	ROHS3 Compliant

MAX4541ETA+T Overview

The electronic part can be shipped overseas conveniently because it is packaged in 8-WDFN Exposed Pad. The advanced packaging method Tape & Reel (TR) provides high reliability. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operational temperature extended around -40°C~85°C TA. In total, there are 8 terminations. The electronic part provides high-quality output because it has 2 channels. When a voltage supply of 5V is used, the electronic component should be turned on and run. Multiplexers built on a SPST - NO switching circuit are built. The multiplexer consists of 2 circuits. Using the MAX4541 search parameter, you can discover variants of the switch. A 60Ohm internal resistance characterizes this multiplexer. To find out what the 8 pins do, please refer to the datasheets. It is normally recommended that users do not supply the multiplexer with voltages higher than 12V. Analog switch ics with Single supply type are cost-effective. 2.7V is the lowest voltage the electrical component should receive. An operating current of 100pA would be sufficient for this switch device. A voltage of 2.7V~12V is required to drain this analog switch from a single voltage supply.