MAX4542EKA-T
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | SOT-23-8 |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| JESD-609 Code | e4 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| Terminal Finish | NICKEL PALLADIUM GOLD |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 2 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Pin Count | 8 |
| JESD-30 Code | R-PDSO-G8 |
| Qualification Status | Not Qualified |
| Number of Channels | 1 |
| Number of Circuits | 2 |
| On-State Resistance (Max) | 60Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 76 dB |
| Current - Leakage (IS(off)) (Max) | 100pA |
| Channel Capacitance (CS(off), CD(off)) | 8pF 8pF |
| On-state Resistance Match-Nom | 0.8Ohm |
| Switch Circuit | SPST - NC |
| Switch Time (Ton, Toff) (Max) | 100ns, 75ns |
| Charge Injection | 1pC |
| Channel-to-Channel Matching (ΔRon) | 800m Ω |
| Crosstalk | -90dB @ 1MHz |
| Switch-on Time-Max | 100ns |
| Switch-off Time-Max | 75ns |
| Voltage - Supply, Single (V+) | 2.7V~12V |
| Height Seated (Max) | 1.45mm |
| RoHS Status | Non-RoHS Compliant |
MAX4542EKA-T Overview
The electronic part can be shipped overseas conveniently because it is packaged in SOT-23-8. High reliability is ensured by the advanced packaging method Tape & Reel (TR). Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have the same number of circuits 1:1. Temperatures around -40°C~85°C TA are extended for operation. 8 terminations have been made so far. As a result of its 1 channels, this electronic component provides high-quality output. An 5V voltage supply should allow the electrical part to be turned on and run. The electronic part body is injected with 8 pins. Based on SPST - NC switching circuits, these analog multiplexers work. Circuits number 2 make up this analogue multiplexer. The voltage required by this switch device is 2.7V~12V, draining from a single voltage supply.
MAX4542EKA-T Features
1 Channels
Switch Circuit: SPST - NC
MAX4542EKA-T Applications
There are a lot of Rochester Electronics, LLC MAX4542EKA-T Analog Switches & Multiplexers ICs applications.
- Central office
- Intelligent PBX
- Transmit
- Medical
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Power routing
- Routers
- Cable Modem
- Microprocessor Controlled Analog Systems
- Sample-and-hold systems
