MAX4543ESA+

100ns, 75ns SPST - NO/NC 60Ohm DUAL Analog Switches BREAK-BEFORE-MAKE MAX4543 8 Pins 100pA 5V 8-SOIC (0.154, 3.90mm Width)

Manufacturer: Maxim Integrated
Nocochips NO: 503-MAX4543ESA+
Package: 8-SOIC (0.154, 3.90mm Width)
Datasheet: PDF
Stock: 721
Description: 100ns, 75ns SPST - NO/NC 60Ohm DUAL Analog Switches BREAK-BEFORE-MAKE MAX4543 8 Pins 100pA 5V 8-SOIC (0.154, 3.90mm Width)(Kg)

Inquiry Now

Details

Tags

Parameters
Factory Lead Time	1 Week
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	8-SOIC (0.154, 3.90mm Width)
Number of Pins	8
Operating Temperature	-40°C~85°C TA
Packaging	Tube
Published	2007
JESD-609 Code	e3
Pbfree Code	yes
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	8
ECCN Code	EAR99
Resistance	60Ohm
Terminal Finish	Matte Tin (Sn)
Subcategory	Multiplexer or Switches
Max Power Dissipation	471mW
Technology	CMOS
Terminal Position	DUAL
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	2
Supply Voltage	5V
Time@Peak Reflow Temperature-Max (s)	30
Base Part Number	MAX4543
Output	SEPARATE OUTPUT
Pin Count	8
Operating Supply Voltage	9V
Power Supplies	3.3/5V
Number of Channels	1
Number of Circuits	2
Max Supply Voltage	12V
Min Supply Voltage	2.7V
Nominal Supply Current	1μA
Max Supply Current	1μA
Throw Configuration	SPST
Turn On Delay Time	125 ns
Supply Type	Single
Turn-Off Delay Time	400 ns
On-State Resistance (Max)	60Ohm
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	76 dB
Current - Leakage (IS(off)) (Max)	100pA
Channel Capacitance (CS(off), CD(off))	8pF 8pF
On-state Resistance Match-Nom	0.8Ohm
Switch Circuit	SPST - NO/NC
Switch Time (Ton, Toff) (Max)	100ns, 75ns
Charge Injection	1pC
Channel-to-Channel Matching (ΔRon)	800m Ω
Crosstalk	-90dB @ 1MHz
Switching	BREAK-BEFORE-MAKE
Switch-on Time-Max	100ns
Switch-off Time-Max	75ns
Voltage - Supply, Single (V+)	2.7V~12V
Height Seated (Max)	1.75mm
Length	4.9mm
Width	3.9mm
Radiation Hardening	No
RoHS Status	ROHS3 Compliant

MAX4543ESA+ Overview

The electronic part can be shipped overseas conveniently because it is packaged in 8-SOIC (0.154, 3.90mm Width). High reliability is achieved by using advanced packaging method Tube. Surface Mount is where this multiplexer is located. Multiplexer and demultiplexer circuits have a number 1:1. Operating temperature around -40°C~85°C TA extended. The total number of terminations is 8. A 1 channel electronic part produces high-quality output. When the electronic component is given a voltage of 5V, it should be turned on and run. There is an electrical component included in the 8 series. On the other hand, analog switches can be constructed using SPST - NO/NC switching circuits. Circuits number 2 make up this analogue multiplexer. Try searching for MAX4543 variants of the analog switch ic. In this multiplexer, the internal resistance is 60Ohm. You can find the functions of the 8 pins in the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 12V. Analog switch ics with Single supply type are cost-effective. 2.7V is the lowest voltage the electrical component should receive. This analogue multiplexer requires a voltage of 2.7V~12V when it drains from a single voltage supply. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. 9V operating voltages are supported by the electronic component.