MAX4580CAE
| Parameters | |
|---|---|
| Min Supply Voltage | 4.5V |
| Nominal Supply Current | 5μA |
| Max Supply Current | 500nA |
| Throw Configuration | SPST |
| Turn On Delay Time | 210 ns |
| Voltage - Supply, Single/Dual (±) | 4.5V~36V ±4.5V~20V |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 160 ns |
| Max Dual Supply Voltage | 20V |
| On-State Resistance (Max) | 1.25Ohm |
| Min Dual Supply Voltage | 4.5V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 53 dB |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 115pF |
| On-state Resistance Match-Nom | 0.25Ohm |
| Switch Circuit | SPST - NC |
| Switch Time (Ton, Toff) (Max) | 160ns, 210ns |
| Charge Injection | -60pC |
| Channel-to-Channel Matching (ΔRon) | 500m Ω |
| Crosstalk | -65dB @ 1MHz |
| Normal Position | NC |
| Height Seated (Max) | 1.99mm |
| Radiation Hardening | No |
| REACH SVHC | Unknown |
| RoHS Status | Non-RoHS Compliant |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SSOP (0.209, 5.30mm Width) |
| Number of Pins | 16 |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Published | 2003 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 1.25Ohm |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 571mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 245 |
| Number of Functions | 2 |
| Supply Voltage | 15V |
| Terminal Pitch | 0.65mm |
| Base Part Number | MAX4580 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Operating Supply Voltage | 20V |
| Power Supplies | 5/30/+-5/+-15V |
| Number of Channels | 1 |
| Number of Circuits | 2 |
| Max Supply Voltage | 36V |
MAX4580CAE Overview
Due to its 16-SSOP (0.209, 5.30mm Width) packaging, the electronic part is convenient for international shipping. High reliability is ensured by the advanced packaging method Tube. Mounted in Surface Mount is this multiplexer. 1:1 is the ratio between multiplexers and demultiplexers. Operating temperature around 0°C~70°C TA extended. Total terminations are 16. A electrical component with 1 channels is capable of high-quality output. In the case of a voltage supply of 15V volts, the electrical part can be powered up and run. There is an electrical component included in the 16 series. Based on SPST - NC switching circuits, these analog multiplexers work. The circuits in this analogue multiplexer number 2. Try searching for MAX4580 variants of the analog switch ic. This digital multiplexer has 1.25Ohm internal resistance. The datasheets for the 16 pins explain the functions. This switch device is a typical Multiplexer or Switches. It is generally not recommended to supply a voltage higher than 36V to the switch device in normal circumstances. Digital switch that provides Dual, Single power at a cost-effective price. 4.5V is the lowest voltage the electrical component should receive. A voltage higher than 500nA may cause damage to the switch multiplexer. If put voltage greater than 20V on the multiplexer, damage may be caused to the device. It is recommended that you attach at least 4.5V to your dual power supply. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. Operating voltages of 20V are compatible with the electrical part.
MAX4580CAE Features
1 Channels
Switch Circuit: SPST - NC
MAX4580CAE Applications
There are a lot of Maxim Integrated MAX4580CAE Analog Switches & Multiplexers ICs applications.
- Routers
- Relay replacements
- Precision data acquisition
- 65 V DACs
- CSU
- PBX interfaces
- Video switching
- Precision test equipment
- SDH/SONET multiplexers
- FTTH
