MAX4581LESE+T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 16 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2012 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 80Ohm |
| Max Power Dissipation | 696mW |
| Base Part Number | MAX4581 |
| Operating Supply Voltage | 12V |
| Number of Circuits | 1 |
| Max Supply Voltage | 12.6V |
| Min Supply Voltage | 2V |
| Operating Supply Current | 1μA |
| Propagation Delay | 200 ns |
| Turn On Delay Time | 200 ns |
| Logic Function | Multiplexer |
| Supply Type | Dual, Single |
| Turn-Off Delay Time | 100 ns |
| On-State Resistance (Max) | 80Ohm |
| Multiplexer/Demultiplexer Circuit | 8:1 |
| Current - Leakage (IS(off)) (Max) | 2nA |
| Channel Capacitance (CS(off), CD(off)) | 4pF 18pF |
| Switch Time (Ton, Toff) (Max) | 200ns, 100ns |
| Charge Injection | 0.5pC |
| Channel-to-Channel Matching (ΔRon) | 1 Ω |
| Crosstalk | -96dB @ 1MHz |
| Voltage - Supply, Single (V+) | 2V~12V |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
MAX4581LESE+T Overview
The electronic part can be shipped overseas conveniently because it is packaged in 16-SOIC (0.154, 3.90mm Width). This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). Multiplexers like this are mounted in the Surface Mount position. There is 8:1 ratio between the number of multiplexers and demultiplexers. Extended operating temperature around -40°C~85°C TA. This multiplexer is composed of 1 circuits. Try searching with MAX4581 if you're looking for variants. An switch multiplexer with 80Ohm internal resistance has a value of 80Ohm. For details about the functions of 16 pins, please refer to the datasheets. Users should never supply a voltage higher than 12.6V to a switch device. The analog switch ic is of the Dual, Single supply type and is cost-effective. There should be 2V voltage fed to the electrical part below 2V. 1μA current would be enough for this multiplexer to operate. Analogue multiplexers require a 2V~12V voltage to drain from a single voltage supply. It can operate from 12V operating voltages.
MAX4581LESE+T Features
1μA Supply Current
MAX4581LESE+T Applications
There are a lot of Maxim Integrated MAX4581LESE+T Analog Switches & Multiplexers ICs applications.
- 65 V DACs
- USB 1.1 signal switching circuits
- Voice over IP/DSL – Integrated Access Devices, Smart
- High reliability control systems
- Ultrasound
- Avionics and Military Systems
- Sample hold systems
- Sample-and-hold systems
- E1 Network Equipment
- Relay Replacement
