MAX4590EAE
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SSOP (0.209, 5.30mm Width) |
| Number of Pins | 16 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2003 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 1.25Ohm |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 571mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 245 |
| Number of Functions | 2 |
| Supply Voltage | 15V |
| Terminal Pitch | 0.65mm |
| Base Part Number | MAX4590 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Operating Supply Voltage | 20V |
| Power Supplies | 5/30/+-5/+-15V |
| Number of Channels | 1 |
| Number of Circuits | 2 |
| Max Supply Voltage | 36V |
| Min Supply Voltage | 4.5V |
| Nominal Supply Current | 5μA |
| Max Supply Current | 500nA |
| Throw Configuration | SPST |
| Turn On Delay Time | 210 ns |
| Voltage - Supply, Single/Dual (±) | 4.5V~36V ±4.5V~20V |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 160 ns |
| Max Dual Supply Voltage | 20V |
| On-State Resistance (Max) | 1.25Ohm |
| Min Dual Supply Voltage | 4.5V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 53 dB |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 115pF 115pF |
| On-state Resistance Match-Nom | 0.05Ohm |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 160ns, 210ns |
| Charge Injection | -60pC |
| Channel-to-Channel Matching (ΔRon) | 50m Ω |
| Crosstalk | -65dB @ 1MHz |
| Normal Position | NO |
| Height Seated (Max) | 1.99mm |
| Radiation Hardening | No |
| REACH SVHC | Unknown |
| RoHS Status | Non-RoHS Compliant |
MAX4590EAE Overview
Shipping overseas is convenient with the electronic component packed in 16-SSOP (0.209, 5.30mm Width). A high level of reliability can be achieved through the use of an advanced packaging method Tube. In Surface Mount, this analog switch is mounted. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Increasing operating temperature to around -40°C~85°C TA. The total number of terminations is 16. As a result of its 1 channels, this electronic component provides high-quality output. When the electronic component is given a voltage of 15V, it should be turned on and run. There are 16 pins injected into the electronic part body. Multiplexers built on a SPST - NO switching circuit are built. The multiplexer consists of 2 circuits. Try searching with MAX4590 if you're looking for variants. As far as internal resistance is concerned, it has 1.25Ohm. The datasheets for the 16 pins explain the functions. There is Multiplexer or Switches analog multiplexer like this in the world. A voltage higher than 36V should not normally be supplied to the switches. A analog switch ic that has a cost-effective Dual, Single supply type. 4.5V should be the lowest voltage fed to the electronic component. If you put voltage higher than 500nA on the digital multiplexer, damage may occur. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 20V. If you are using a dual power supply, you should attach at least 4.5V. This analog switch ic utilizes SEPARATE OUTPUT output. 20V operating voltages can be used with this electrical part.
MAX4590EAE Features
1 Channels
Switch Circuit: SPST - NO
MAX4590EAE Applications
There are a lot of Maxim Integrated MAX4590EAE Analog Switches & Multiplexers ICs applications.
- Audio/video switches
- Channel Banks
- Multi-Line E1 Interface Cards
- Remote wireless modules
- Fiber In The Loop (FITL)
- PDAs
- Industrial
- Residential Gateways, Home Gateway/Router
- Relay Replacement
- Digital access cross connects
