banner_page

MAX4592EUE

80ns, 45ns SPST - NO 20Ohm DUAL Analog Switches BREAK-BEFORE-MAKE MAX4592 16 Pins 100pA 12V 16-TSSOP (0.173, 4.40mm Width)


  • Manufacturer: Maxim Integrated
  • Nocochips NO: 503-MAX4592EUE
  • Package: 16-TSSOP (0.173, 4.40mm Width)
  • Datasheet: PDF
  • Stock: 997
  • Description: 80ns, 45ns SPST - NO 20Ohm DUAL Analog Switches BREAK-BEFORE-MAKE MAX4592 16 Pins 100pA 12V 16-TSSOP (0.173, 4.40mm Width)(Kg)

Details

Tags

Parameters
Mounting Type Surface Mount
Package / Case 16-TSSOP (0.173, 4.40mm Width)
Surface Mount YES
Operating Temperature -40°C~85°C TA
Packaging Tube
Published 2000
JESD-609 Code e0
Pbfree Code no
Part Status Obsolete
Moisture Sensitivity Level (MSL) 1 (Unlimited)
Number of Terminations 16
ECCN Code EAR99
Terminal Finish Tin/Lead (Sn85Pb15)
Additional Feature CAN ALSO OPERATES AT 15 V SUPPLY, OVERVOLTAGE PROTECTION
Subcategory Multiplexer or Switches
Technology CMOS
Terminal Position DUAL
Terminal Form GULL WING
Peak Reflow Temperature (Cel) 240
Number of Functions 4
Supply Voltage 12V
Terminal Pitch 0.65mm
Reach Compliance Code not_compliant
Time@Peak Reflow Temperature-Max (s) 20
Base Part Number MAX4592
Output SEPARATE OUTPUT
Pin Count 16
JESD-30 Code R-PDSO-G16
Qualification Status Not Qualified
Supply Voltage-Max (Vsup) 16V
Power Supplies 12/15V
Number of Channels 1
Number of Circuits 4
On-State Resistance (Max) 20Ohm
Multiplexer/Demultiplexer Circuit 1:1
Off-state Isolation-Nom 72 dB
Current - Leakage (IS(off)) (Max) 100pA
Channel Capacitance (CS(off), CD(off)) 9pF 9pF
On-state Resistance Match-Nom 0.5Ohm
Switch Circuit SPST - NO
Switch Time (Ton, Toff) (Max) 80ns, 45ns
Charge Injection 2pC
Channel-to-Channel Matching (ΔRon) 500m Ω
Crosstalk -85dB @ 10MHz
Switching BREAK-BEFORE-MAKE
Switch-on Time-Max 90ns
Switch-off Time-Max 50ns
Voltage - Supply, Single (V+) 3V~16V
Normal Position NO
Height Seated (Max) 1.1mm
Length 5mm
RoHS Status Non-RoHS Compliant

MAX4592EUE Overview


Packed in 16-TSSOP (0.173, 4.40mm Width), the electronic component is convenient for shipping overseas. Advanced packaging method Tube is used to provide high reliability. Mounted in Surface Mount is this multiplexer. 1:1 is the ratio between multiplexers and demultiplexers. Increasing operating temperature to around -40°C~85°C TA. In total, there are 16 terminations. As a result of its 1 channels, this electronic component provides high-quality output. In the case of a voltage supply of 12V volts, the electrical part can be powered up and run. The electrical component body receives 16 pins. SPST - NO switching circuits are used in these analog switch ics. There are 4 circuits in this multiplexer. Try searching with MAX4592 if you're looking for variants. The analog multiplexer shown here is a typical Multiplexer or Switches. A voltage of 3V~16V is required to drain this analog switch from a single voltage supply. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. Don’t miss additional features of the electronic component such as: CAN ALSO OPERATES AT 15 V SUPPLY, OVERVOLTAGE PROTECTION.

MAX4592EUE Features


1 Channels
Switch Circuit: SPST - NO
Additional Features: CAN ALSO OPERATES AT 15 V SUPPLY, OVERVOLTAGE PROTECTION

MAX4592EUE Applications


There are a lot of Maxim Integrated MAX4592EUE Analog Switches & Multiplexers ICs applications.

  • DSLAMs
  • Imaging
  • Existing multiplexer applications (both fault-protected and nonfault-protected)
  • MP3 players
  • E1 Multiplexer
  • Audio and video signal routing
  • Avionics test equipment
  • ISDN NT1/TA
  • SONET/SDH ADM
  • Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads

Write a review

Note: HTML is not translated!
    Bad           Good