MAX4600EWE+
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.295, 7.50mm Width) |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2003 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 1.25Ohm |
| Max Power Dissipation | 762mW |
| Base Part Number | MAX4600 |
| Number of Circuits | 2 |
| Max Supply Voltage | 20V |
| Min Supply Voltage | 4.5V |
| Nominal Supply Current | 10nA |
| Max Supply Current | 500nA |
| Throw Configuration | SPST |
| Turn On Delay Time | 160 ns |
| Voltage - Supply, Single/Dual (±) | 4.5V~36V ±4.5V~20V |
| Supply Type | Dual, Single |
| Turn-Off Delay Time | 210 ns |
| Max Dual Supply Voltage | 20V |
| On-State Resistance (Max) | 1.25Ohm |
| Min Dual Supply Voltage | 4.5V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 115pF 115pF |
| Switch Circuit | SPST - NO/NC |
| Switch Time (Ton, Toff) (Max) | 160ns, 210ns |
| Charge Injection | -60pC |
| Channel-to-Channel Matching (ΔRon) | 50m Ω |
| Crosstalk | -65dB @ 1MHz |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
MAX4600EWE+ Overview
As the electronic part is packed in 16-SOIC (0.295, 7.50mm Width), international shipping is convenient. High reliability is achieved by using advanced packaging method Tube. This analog switch is mounted in Surface Mount. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operation at a temperature around -40°C~85°C TA. A SPST - NO/NC switching circuit is used for these analog switches. 2 circuits are used in this analogue multiplexer. MAX4600 can be used to search for analog multiplexer variants. Analog switches have 1.25Ohm internal resistance. An abnormal situation would be for the switch device to be supplied with a voltage greater than 20V. Dual, Single supply type digital switch with a low cost. 4.5V is the lowest voltage the electrical component should receive. When the digital multiplexer is charged above 500nA, damage can occur. There is no problem with using dual supply voltage, but it should not exceed 20V. If you are using dual power supplies, you should attach at least 4.5V.
MAX4600EWE+ Features
Switch Circuit: SPST - NO/NC
MAX4600EWE+ Applications
There are a lot of Maxim Integrated MAX4600EWE+ Analog Switches & Multiplexers ICs applications.
- Voice over IP/DSL – Integrated Access Devices, Smart
- Frame Relay Equipment
- Remote wireless modules
- FTTH
- Signal routing between systems
- Battery Powered Systems
- Communication systems
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- Medical systems
- USB 1.1 signal switching circuits
