Parameters |
Mount |
Through Hole |
Package / Case |
DIP |
Number of Pins |
16 |
Packaging |
Tube |
Published |
1999 |
JESD-609 Code |
e3 |
Pbfree Code |
yes |
Part Status |
Obsolete |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
16 |
ECCN Code |
EAR99 |
Resistance |
2.5Ohm |
Terminal Finish |
MATTE TIN |
Max Operating Temperature |
85°C |
Min Operating Temperature |
-40°C |
Max Power Dissipation |
571mW |
Technology |
CMOS |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
4 |
Supply Voltage |
15V |
Pin Count |
16 |
Operating Supply Voltage |
20V |
Temperature Grade |
INDUSTRIAL |
Number of Channels |
1 |
Number of Circuits |
4 |
Max Supply Voltage |
36V |
Min Supply Voltage |
4.5V |
Nominal Supply Current |
5μA |
Max Supply Current |
500nA |
Throw Configuration |
SPST |
Turn On Delay Time |
350 ns |
Supply Type |
Dual, Single |
Neg Supply Voltage-Nom (Vsup) |
-15V |
Turn-Off Delay Time |
250 ns |
Max Dual Supply Voltage |
20V |
Min Dual Supply Voltage |
4.5V |
Off-state Isolation-Nom |
56 dB |
On-state Resistance Match-Nom |
0.1Ohm |
Length |
19.175mm |
Width |
7.62mm |
Radiation Hardening |
No |
RoHS Status |
ROHS3 Compliant |
MAX4601EPE+ Overview
The electronic component is convenient to ship overseas because it is packed in a DIP. This packaging method provides high reliability because it uses advanced packaging techniques. Total terminations are 16. A high-quality output is provided by the electrical component's 1 channels. When a voltage supply of 15V is used, the electronic component should be turned on and run. An electrical component like this is included in the 16 series. It consists of 4 circuits. In this multiplexer, the internal resistance is 2.5Ohm. Datasheets for functions of 16 pins are available. It is generally not recommended to supply a voltage higher than 36V to the switch device in normal circumstances. Analog switch ics with Dual, Single supply type are cost-effective. It is recommended to use 4.5V as the lowest voltage for the electrical part. A digital multiplexer may suffer damage if voltage is applied above 500nA. There is no problem with using dual supply voltage, but it should not exceed 20V. The voltage should be at least 4.5V if you are using dual power supplies. 20V operating voltages are supported by the electronic component. In an environment with a temperature higher than 85°C, the digital switches should not operate.
MAX4601EPE+ Features
1 Channels
MAX4601EPE+ Applications
There are a lot of Maxim Integrated MAX4601EPE+ Analog Switches & Multiplexers ICs applications.
- DSLAMs
- SDH/SONET multiplexers
- Data switching
- New designs requiring multiplexer functions
- Communication systems
- Relay Replacement
- Signal routing between systems
- SDH
- Ultrasound
- Sample-and-hold systems