MAX4601EWE
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.295, 7.50mm Width) |
| Surface Mount | YES |
| Number of Pins | 16 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 1999 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 2.5Ohm |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Terminal Pitch | 1.27mm |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Base Part Number | MAX4601 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Power Supplies | 12/+-15V |
| Number of Channels | 1 |
| Number of Circuits | 4 |
| Max Supply Voltage | 36V |
| Min Supply Voltage | 4.5V |
| Voltage - Supply, Single/Dual (±) | 4.5V~36V ±4.5V~20V |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Max Dual Supply Voltage | 20V |
| On-State Resistance (Max) | 2.5Ohm |
| Min Dual Supply Voltage | 4.5V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 56 dB |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 55pF 55pF |
| On-state Resistance Match-Nom | 0.1Ohm |
| Switch Circuit | SPST - NC |
| Switch Time (Ton, Toff) (Max) | 250ns, 350ns |
| Charge Injection | 120pC |
| Channel-to-Channel Matching (ΔRon) | 100m Ω |
| Crosstalk | -59dB @ 1MHz |
| Switch-on Time-Max | 250ns |
| Switch-off Time-Max | 350ns |
| Normal Position | NC |
| Height Seated (Max) | 2.65mm |
| Length | 10.3mm |
| Width | 7.5mm |
| Radiation Hardening | No |
| RoHS Status | Non-RoHS Compliant |
MAX4601EWE Overview
As the electronic part is packed in 16-SOIC (0.295, 7.50mm Width), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tube. Mounted in Surface Mount is this multiplexer. Multiplexers and demultiplexers have a number of circuits 1:1. Operating temperature extended to -40°C~85°C TA. 16 terminations have been made so far. This electronic part offers high-quality output due to its 1 channels. An 15V voltage supply should allow the electrical part to be turned on and run. There are 16 pins injected into the electronic part body. Unlike digital switches, these are based on SPST - NC switching circuits. It consists of 4 circuits. Try searching for MAX4601 variants of the analog switch ic. Internally, this switch multiplexer has a resistance of 2.5Ohm. Please refer to the datasheets for 16 pins functions. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 36V. In order for the electronic part to function properly, the lowest voltage should be 4.5V. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 20V. A dual power supply should have at least 4.5V voltage attached. In this switch multiplexer, there are SEPARATE OUTPUT outputs available.
MAX4601EWE Features
1 Channels
Switch Circuit: SPST - NC
MAX4601EWE Applications
There are a lot of Maxim Integrated MAX4601EWE Analog Switches & Multiplexers ICs applications.
- Channel Banks
- E1 Multiplexer
- High speed data transmission line cards
- Data switching
- Audio and video signal routing
- Fault Tolerant Systems
- Voice over IP/DSL – Integrated Access Devices, Smart
- Cell phones
- T1/E1 Terminals
- Automotive applications
