MAX4603CAE
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SSOP (0.209, 5.30mm Width) |
| Number of Pins | 16 |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Published | 1999 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| Resistance | 2.5Ohm |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 762mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 245 |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Terminal Pitch | 0.65mm |
| Base Part Number | MAX4603 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Operating Supply Voltage | 20V |
| Power Supplies | 12/+-15V |
| Number of Channels | 1 |
| Number of Circuits | 4 |
| Max Supply Voltage | 36V |
| Min Supply Voltage | 4.5V |
| Nominal Supply Current | 5μA |
| Max Supply Current | 500nA |
| Throw Configuration | SPST |
| Turn On Delay Time | 350 ns |
| Voltage - Supply, Single/Dual (±) | 4.5V~36V ±4.5V~20V |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 250 ns |
| Max Dual Supply Voltage | 20V |
| On-State Resistance (Max) | 2.5Ohm |
| Min Dual Supply Voltage | 4.5V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 56 dB |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 55pF 55pF |
| On-state Resistance Match-Nom | 0.1Ohm |
| Switch Circuit | SPST - NO/NC |
| Switch Time (Ton, Toff) (Max) | 250ns, 350ns |
| Charge Injection | 120pC |
| Channel-to-Channel Matching (ΔRon) | 100m Ω |
| Crosstalk | -59dB @ 1MHz |
| Height Seated (Max) | 1.99mm |
| Length | 6.2mm |
| Width | 5.29mm |
| Radiation Hardening | No |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
MAX4603CAE Overview
The electronic component is convenient to ship overseas because it is packed in a 16-SSOP (0.209, 5.30mm Width). High reliability is provided by advanced packaging method Tube. The multiplexer is located in Surface Mount. 1:1 is the number of circuits in the multiplexer and demultiplexer. An extended operating temperature of 0°C~70°C TA degrees Celsius. 16 terminations have been made so far. The electronic part delivers high-quality output through its 1 channels. Turning on and running the electrical part should be easy with a 15V voltage supply. It is injected into the electrical part body with 16 pins. These analog multiplexers are built based on SPST - NO/NC switching circuits. 4 circuits are used in this analogue multiplexer. Try searching for the analog switch ic with MAX4603 if you are looking for variants. It has an internal resistance of 2.5Ohm. The functions of 16 pins can be found in the datasheets. It is a typical Multiplexer or Switches analog multiplexer. An abnormal situation would be for the switch device to be supplied with a voltage greater than 36V. Analogue multiplexers of the Dual, Single supply type that are cost-effective. The lowest voltage fed to the electronic component should be 4.5V. It may damage the digital multiplexer if the voltage is higher than 500nA. Dual supply volatge is feasible for this multiplexer. But it should not go beyond 20V. If you are using a dual power supply, you should attach at least 4.5V. In this switch multiplexer, there are SEPARATE OUTPUT outputs available. Operating voltages of 20V are compatible with the electrical part.
MAX4603CAE Features
1 Channels
Switch Circuit: SPST - NO/NC
MAX4603CAE Applications
There are a lot of Maxim Integrated MAX4603CAE Analog Switches & Multiplexers ICs applications.
- High reliability control systems
- Cable Telephony – NIU, Set-Top Box, Home Side Box
- Fiber to the Home
- Industrial
- Video switching
- Remote wireless modules
- Audio and video signal routing
- Cable Modem
- High speed data transmission line cards
- New designs requiring multiplexer functions
