MAX4605ESE+T
| Parameters | |
|---|---|
| Package / Case | SOIC |
| Surface Mount | YES |
| Number of Pins | 16 |
| Packaging | Tape & Reel (TR) |
| Published | 1999 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| Terminal Finish | Matte Tin (Sn) |
| HTS Code | 8542.39.00.01 |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Terminal Pitch | 1.27mm |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Operating Temperature (Max) | 85°C |
| Operating Temperature (Min) | -40°C |
| Power Supplies | 5/30/+-5/+-15V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 36V |
| Min Supply Voltage | 4.5V |
| Analog IC - Other Type | SPST |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Max Dual Supply Voltage | 20V |
| On-State Resistance (Max) | 4Ohm |
| Min Dual Supply Voltage | 4.5V |
| Off-state Isolation-Nom | 62 dB |
| On-state Resistance Match-Nom | 0.2Ohm |
| Switch-on Time-Max | 220ns |
| Normal Position | NO |
| Height Seated (Max) | 1.75mm |
| Length | 9.9mm |
| Width | 3.9mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
MAX4605ESE+T Overview
Presented in SOIC, this electrical component is convenient for overseas shipping. High reliability is ensured by the advanced packaging method Tape & Reel (TR). In total, there are 16 terminations. As a result of its 1 channels, this electronic component provides high-quality output. Turning on and running the electrical part should be easy with a 15V voltage supply. This electronic part can be found in the 16 series. Datasheets for functions of 16 pins are available. There is a standard Multiplexer or Switches analogue multiplexer here. It is normally recommended that users do not supply the multiplexer with voltages higher than 36V. 4.5V is the lowest voltage the electrical component should receive. For this switch, a dual supply voltage is feasible, but it must not exceed 20VIf you are using dual power supplies, you should attach at least 4.5V. A SPST analog IC is integrated into the board. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. A temperature higher than 85°C may result in a malfunction of the switch multiplexer. A setting of over -40°C should be applied to the operating environment.
MAX4605ESE+T Features
1 Channels
MAX4605ESE+T Applications
There are a lot of Maxim Integrated MAX4605ESE+T Analog Switches & Multiplexers ICs applications.
- Avionics test equipment
- DSLAMs
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Medical
- Video switching
- PCMCIA cards
- RGB switches
- Microprocessor Controlled Analog Systems
- Avionics
- Industrial control systems
