MAX4610ESD+TG074
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 14-SOIC (0.154, 3.90mm Width) |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2009 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 100Ohm |
| Max Power Dissipation | 640mW |
| Base Part Number | MAX4610 |
| Number of Circuits | 4 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2V |
| Operating Supply Current | 1μA |
| Nominal Supply Current | 1μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 47 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 100 ns |
| -3db Bandwidth | 300MHz |
| On-State Resistance (Max) | 100Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Current - Leakage (IS(off)) (Max) | 100pA |
| Channel Capacitance (CS(off), CD(off)) | 16pF 16pF |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 65ns, 28ns |
| Charge Injection | 1pC |
| Channel-to-Channel Matching (ΔRon) | 1 Ω |
| Crosstalk | -80dB @ 1MHz |
| Voltage - Supply, Single (V+) | 2V~12V |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
MAX4610ESD+TG074 Overview
The electronic part can be shipped overseas conveniently because it is packaged in 14-SOIC (0.154, 3.90mm Width). High reliability is achieved by using advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. The operating temperature is extended to around -40°C~85°C TA. These analog multiplexers are built based on SPST - NO switching circuits. A total of 4 circuits make up this switch device. Look for analog switch ic variants by searching with MAX4610. In this multiplexer, the internal resistance is 100Ohm. normally, users should not supply switches with voltages higher than 12V. A cost-effective Single supply type analogue multiplexer. In order for the electronic part to function properly, the lowest voltage should be 2V. The switch device would be able to operate with 1μA current. A voltage of 2V~12V is required to drain this analog switch from a single voltage supply.
MAX4610ESD+TG074 Features
Switch Circuit: SPST - NO
1μA Supply Current
-3db Bandwidth: 300MHz
MAX4610ESD+TG074 Applications
There are a lot of Maxim Integrated MAX4610ESD+TG074 Analog Switches & Multiplexers ICs applications.
- High reliability control systems
- PDAs
- Medical
- Modems
- Audio and video routing
- Audio and video signal routing
- Mechanical reed relay replacement
- Cellular phones
- Medical systems
- USB 1.1 signal switching circuits
