Parameters |
Factory Lead Time |
1 Week |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
14-TSSOP (0.173, 4.40mm Width) |
Number of Pins |
14 |
Operating Temperature |
-40°C~85°C TA |
Packaging |
Tube |
Published |
2009 |
JESD-609 Code |
e3 |
Pbfree Code |
yes |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
14 |
ECCN Code |
EAR99 |
Resistance |
100Ohm |
Terminal Finish |
Matte Tin (Sn) |
Additional Feature |
ALSO OPERATES AT 5V AND 12V VCC |
Subcategory |
Multiplexer or Switches |
Max Power Dissipation |
640mW |
Technology |
CMOS |
Terminal Position |
DUAL |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
4 |
Supply Voltage |
3V |
Terminal Pitch |
0.65mm |
Time@Peak Reflow Temperature-Max (s) |
30 |
Base Part Number |
MAX4612 |
Output |
SEPARATE OUTPUT |
Pin Count |
14 |
Operating Supply Voltage |
9V |
Number of Channels |
1 |
Number of Circuits |
4 |
Max Supply Voltage |
12V |
Min Supply Voltage |
2V |
Operating Supply Current |
1μA |
Nominal Supply Current |
1μA |
Max Supply Current |
1μA |
Throw Configuration |
SPST |
Turn On Delay Time |
47 ns |
Supply Type |
Single |
Turn-Off Delay Time |
100 ns |
-3db Bandwidth |
300MHz |
On-State Resistance (Max) |
100Ohm |
Multiplexer/Demultiplexer Circuit |
1:1 |
Off-state Isolation-Nom |
60 dB |
Current - Leakage (IS(off)) (Max) |
100pA |
Channel Capacitance (CS(off), CD(off)) |
16pF 16pF |
On-state Resistance Match-Nom |
2Ohm |
Switch Circuit |
SPST - NO/NC |
Switch Time (Ton, Toff) (Max) |
65ns, 28ns |
Charge Injection |
1pC |
Channel-to-Channel Matching (ΔRon) |
1 Ω |
Crosstalk |
-80dB @ 1MHz |
Switching |
BREAK-BEFORE-MAKE |
Switch-on Time-Max |
90ns |
Voltage - Supply, Single (V+) |
2V~12V |
Height Seated (Max) |
1.1mm |
Length |
5mm |
Radiation Hardening |
No |
RoHS Status |
ROHS3 Compliant |
MAX4612EUD+ Overview
This electronic part is conveniently packaged in 14-TSSOP (0.173, 4.40mm Width), making it easy to ship abroad. High reliability is achieved by using advanced packaging method Tube. There is an analog multiplexer mounted in position Surface Mount. 1:1 is the ratio between multiplexers and demultiplexers. Operation at a temperature around -40°C~85°C TA. A total of 14 terminations have been recorded. By its 1 channels, the electronic component provides high-quality output. A 3V voltage supply should turn on and run the electronic component. An electrical component of this type can be found in the 14 series. These analog multiplexers are built based on SPST - NO/NC switching circuits. It consists of 4 circuits. Using the MAX4612 search parameter, you can discover variants of the switch. This digital multiplexer has 100Ohm internal resistance. The datasheets for the 14 pins explain the functions. Multiplexer or Switches is a typical switch device. It is normally recommended that users do not supply the multiplexer with voltages higher than 12V. The digital multiplexer has a low cost Single supply. In order for the electronic part to function properly, the lowest voltage should be 2V. In order to operate this switch device, it would need a current of 1μA. This analog switch requires a voltage of 2V~12V to drain from a single voltage supply. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. In this switch multiplexer, there are SEPARATE OUTPUT outputs available. Operating voltages of 9V are compatible with the electrical part. You shouldn't miss the additional features of the electrical component, such as: ALSO OPERATES AT 5V AND 12V VCC.
MAX4612EUD+ Features
1 Channels
Switch Circuit: SPST - NO/NC
1μA Supply Current
-3db Bandwidth: 300MHz
Additional Features: ALSO OPERATES AT 5V AND 12V VCC
MAX4612EUD+ Applications
There are a lot of Maxim Integrated MAX4612EUD+ Analog Switches & Multiplexers ICs applications.
- Data Acquisition Systems
- Imaging
- CSU
- Modems
- E1 Multiplexer
- Multiplexers
- 65 V DACs
- Video signal routing
- Industrial and process control systems
- Frame Relay Equipment