MAX4621ESE
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 16 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 1999 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 5Ohm |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 696mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 2 |
| Supply Voltage | 15V |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Base Part Number | MAX4621 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Operating Supply Voltage | 20V |
| Number of Channels | 1 |
| Number of Circuits | 2 |
| Max Supply Voltage | 36V |
| Min Supply Voltage | 4.5V |
| Nominal Supply Current | 5μA |
| Max Supply Current | 500nA |
| Throw Configuration | SPST |
| Turn On Delay Time | 200 ns |
| Voltage - Supply, Single/Dual (±) | 4.5V~36V ±4.5V~18V |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 350 ns |
| Max Dual Supply Voltage | 20V |
| On-State Resistance (Max) | 5Ohm |
| Min Dual Supply Voltage | 4.5V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 62 dB |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 34pF 34pF |
| On-state Resistance Match-Nom | 0.25Ohm |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 250ns, 200ns |
| Charge Injection | 480pC |
| Channel-to-Channel Matching (ΔRon) | 250m Ω |
| Crosstalk | -60dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Normal Position | NO |
| Height Seated (Max) | 1.75mm |
| Length | 9.9mm |
| Width | 3.9mm |
| Radiation Hardening | No |
| RoHS Status | Non-RoHS Compliant |
MAX4621ESE Overview
The electronic part can be shipped overseas conveniently because it is packaged in 16-SOIC (0.154, 3.90mm Width). In order to provide high reliability, an advanced packaging method Tube is used. Multiplexers like this are mounted in the Surface Mount position. Multiplexers and demultiplexers have a number of circuits 1:1. Operating temperature extended to -40°C~85°C TA. In total, there are 16 terminations. A 1 channel electronic part produces high-quality output. Powered by a 15V voltage supply, the electrical part should be switched on and run. This electrical component is included in the 16 series of products. A SPST - NO switching circuit is used for these analog switches. 2 circuits are used in this analogue multiplexer. Use MAX4621 to search for variants of the digital switches. It has an internal resistance of 5Ohm. Datasheets for functions of 16 pins are available. This switch device is a typical Multiplexer or Switches. A voltage higher than 36V should not normally be supplied to the switches. A cost-effective Dual, Single supply type analogue multiplexer. There should be 4.5V voltage fed to the electrical part below 4.5V. A digital multiplexer may suffer damage if voltage is applied above 500nA. There is no problem with using dual supply voltage, but it should not exceed 20V. You should attach at least 4.5V voltage if you are using dual power supply. This analog switch ic utilizes SEPARATE OUTPUT output. 20V operating voltages can be used with this electrical part.
MAX4621ESE Features
1 Channels
Switch Circuit: SPST - NO
MAX4621ESE Applications
There are a lot of Maxim Integrated MAX4621ESE Analog Switches & Multiplexers ICs applications.
- Remote wireless modules
- Remote Powered Equipment
- 65 V DACs
- Digital cross connects (DSX-1)
- PCMCIA cards
- Medical Instrumentation
- Battery Powered Systems
- Fault Tolerant Systems
- Multiplexers
- Audio signal routing
