MAX4635ETB+T
| Parameters | |
|---|---|
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | MAX4635 |
| Number of Circuits | 2 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.8V |
| Max Supply Current | 1μA |
| Turn On Delay Time | 14 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 6 ns |
| On-State Resistance (Max) | 4Ohm |
| Multiplexer/Demultiplexer Circuit | 2:1 |
| Current - Leakage (IS(off)) (Max) | 100pA |
| Channel Capacitance (CS(off), CD(off)) | 9pF |
| Switch Circuit | SPDT |
| Switch Time (Ton, Toff) (Max) | 14ns, 6ns |
| Charge Injection | 2pC |
| Channel-to-Channel Matching (ΔRon) | 100m Ω |
| Crosstalk | -67dB @ 1MHz |
| Voltage - Supply, Single (V+) | 1.8V~5.5V |
| RoHS Status | ROHS3 Compliant |
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 10-WFDFN Exposed Pad |
| Number of Pins | 10 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2003 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| ECCN Code | EAR99 |
| Resistance | 4Ohm |
| Max Power Dissipation | 1.951W |
MAX4635ETB+T Overview
Presented in 10-WFDFN Exposed Pad, this electrical component is convenient for overseas shipping. The advanced packaging method Tape & Reel (TR) provides high reliability. Surface Mount is where this multiplexer is located. In the multiplexer and demultiplexer, 2:1 represents the number of circuits. Extended operating temperature around -40°C~85°C TA. Unlike digital switches, these are based on SPDT switching circuits. There are 2 circuits in this switch device. Look for analog switch ic variants by searching with MAX4635. In this multiplexer, the internal resistance is 4Ohm. For details about the functions of 10 pins, please refer to the datasheets. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. A analog switch ic that has a cost-effective Single supply type. It is recommended that the electrical component receives a voltage of 1.8V. A voltage of 1.8V~5.5V is required to drain this analog switch from a single voltage supply. When the digital multiplexer is charged above 1μA, damage can occur.
MAX4635ETB+T Features
Switch Circuit: SPDT
MAX4635ETB+T Applications
There are a lot of Maxim Integrated MAX4635ETB+T Analog Switches & Multiplexers ICs applications.
- Microprocessor Controlled Analog Systems
- USB 1.1 signal switching circuits
- Relay Replacement
- Communication systems
- SONET
- SDH
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Remote Powered Equipment
- PDH Multiplexers
- DVD-R
