MAX4643EUA+TG24
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2002 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 4Ohm |
| Max Power Dissipation | 362mW |
| Base Part Number | MAX4643 |
| Number of Circuits | 2 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.8V |
| Operating Supply Current | 1nA |
| Nominal Supply Current | 1μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 10 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 20 ns |
| On-State Resistance (Max) | 4Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Current - Leakage (IS(off)) (Max) | 250pA |
| Channel Capacitance (CS(off), CD(off)) | 7pF 7pF |
| Switch Circuit | SPST - NO/NC |
| Switch Time (Ton, Toff) (Max) | 15ns, 8ns |
| Charge Injection | 2pC |
| Channel-to-Channel Matching (ΔRon) | 200m Ω |
| Crosstalk | -97dB @ 1MHz |
| Voltage - Supply, Single (V+) | 1.8V~5.5V |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
MAX4643EUA+TG24 Overview
This electronic part is conveniently packaged in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width), making it easy to ship abroad. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. There is 1:1 ratio between the number of multiplexers and demultiplexers. Operation at a temperature around -40°C~85°C TA. These analog multiplexers are built based on SPST - NO/NC switching circuits. This multiplexer is composed of 2 circuits. Try searching with MAX4643 if you're looking for variants. As far as internal resistance is concerned, it has 4Ohm. Please refer to the datasheets for 8 pins functions. A voltage higher than 5.5V should not normally be supplied to the switches. The analog switch ic is of the Single supply type and is cost-effective. A low voltage of 1.8V should be applied to the electronic component. The analogue multiplexer could operate on 1nA current. This analog switch requires a voltage of 1.8V~5.5V to drain from a single voltage supply.
MAX4643EUA+TG24 Features
Switch Circuit: SPST - NO/NC
1nA Supply Current
MAX4643EUA+TG24 Applications
There are a lot of Maxim Integrated MAX4643EUA+TG24 Analog Switches & Multiplexers ICs applications.
- SDH
- Frame Relay Equipment
- High reliability control systems
- Audio and video signal routing
- Mechanical reed relay replacement
- 65 V DACs
- Cross Connects
- MP3 players
- SDH/SONET multiplexers
- Communications systems
