MAX4645EUA
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2004 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Resistance | 2.5Ohm |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 571mW |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Base Part Number | MAX4645 |
| Pin Count | 8 |
| Operating Supply Voltage | 5V |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.8V |
| Operating Supply Current | 100pA |
| Nominal Supply Current | 1μA |
| Max Supply Current | 1μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 10 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 15 ns |
| On-State Resistance (Max) | 2.5Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 55 dB |
| Current - Leakage (IS(off)) (Max) | 250pA |
| Channel Capacitance (CS(off), CD(off)) | 17pF 17pF |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 15ns, 10ns |
| Charge Injection | 5pC |
| Channel-to-Channel Matching (ΔRon) | 100m Ω |
| Switching | BREAK-BEFORE-MAKE |
| Voltage - Supply, Single (V+) | 1.8V~5V |
| Normal Position | NO |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| RoHS Status | Non-RoHS Compliant |
MAX4645EUA Overview
As the electronic part is packed in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width), international shipping is convenient. High reliability is provided by advanced packaging method Tube. This analog switch is mounted in Surface Mount. 1:1 is the ratio between multiplexers and demultiplexers. The operating temperature is extended to around -40°C~85°C TA. 8 terminations have been made so far. As a result of its 1 channels, this electronic component provides high-quality output. Powered by a 3V voltage supply, the electrical part should be switched on and run. This electronic part can be found in the 8 series. These analog multiplexers are built based on SPST - NO switching circuits. Circuits number 1 make up this analogue multiplexer. Using the MAX4645 search parameter, you can discover variants of the switch. It has an internal resistance of 2.5Ohm. To find out what the functions of 8 pins are, please refer to their datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. Multiplexers should not be powered above 5.5V in normal situations. Single supply type digital switch with a low cost. 1.8V is the lowest voltage the electrical component should receive. An operating current of 100pA would be sufficient for this switch device. A voltage of 1.8V~5V is required to drain this analog switch from a single voltage supply. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. There is a voltage range of 5V operating voltages for the electrical part.
MAX4645EUA Features
1 Channels
Switch Circuit: SPST - NO
100pA Supply Current
MAX4645EUA Applications
There are a lot of Maxim Integrated MAX4645EUA Analog Switches & Multiplexers ICs applications.
- Avionics test equipment
- Audio signal routing
- Battery Powered Systems
- Industrial and process control systems
- Battery-powered systems
- Avionics
- Power routing
- Fault Tolerant Systems
- SONET
- FTTH
