MAX4646EUT+T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | SOT-23-6 |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2004 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| Terminal Finish | TIN |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.95mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | MAX4646 |
| Pin Count | 6 |
| JESD-30 Code | R-PDSO-G6 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 5.5V |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| On-State Resistance (Max) | 2.5Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 55 dB |
| Current - Leakage (IS(off)) (Max) | 250pA |
| Channel Capacitance (CS(off), CD(off)) | 17pF 17pF |
| Switch Circuit | SPST - NC |
| Switch Time (Ton, Toff) (Max) | 15ns, 10ns |
| Charge Injection | 5pC |
| Channel-to-Channel Matching (ΔRon) | 100m Ω |
| Voltage - Supply, Single (V+) | 1.8V~5V |
| Length | 2.9mm |
| RoHS Status | ROHS3 Compliant |
MAX4646EUT+T Overview
The electronic part can be shipped overseas conveniently because it is packaged in SOT-23-6. Advanced packaging method Tape & Reel (TR) is used to provide high reliability. Surface Mount is where this multiplexer is located. 1:1 is the number of circuits in the multiplexer and demultiplexer. An extended operating temperature of -40°C~85°C TA degrees Celsius. The total number of terminations is 6. By its 1 channels, the electronic component provides high-quality output. Powered by a 3V voltage supply, the electrical part should be switched on and run. A total of 6 pins are injected into the body of the electronic part. Based on SPST - NC switching circuits, these analog multiplexers work. The circuits in this analogue multiplexer number 1. MAX4646 can be used to search for analog multiplexer variants. A voltage of 1.8V~5V is required for this switch device, which drains from a single voltage source.
MAX4646EUT+T Features
1 Channels
Switch Circuit: SPST - NC
MAX4646EUT+T Applications
There are a lot of Maxim Integrated MAX4646EUT+T Analog Switches & Multiplexers ICs applications.
- Imaging
- Signal routing between systems
- Automotive applications
- Relay replacements
- Battery-powered systems
- Voice over IP/DSL – Integrated Access Devices, Smart
- DSUs
- Digital Cross-Connects
- Cable Modem
- E1 Multiplexer
