MAX4647EUT-T

100ns, 100ns SPST - NC 25Ohm Analog Switches BREAK-BEFORE-MAKE MAX4647 6 Pins 1nA 15V SOT-23-6

Manufacturer: Maxim Integrated
Nocochips NO: 503-MAX4647EUT-T
Package: SOT-23-6
Datasheet: PDF
Stock: 457
Description: 100ns, 100ns SPST - NC 25Ohm Analog Switches BREAK-BEFORE-MAKE MAX4647 6 Pins 1nA 15V SOT-23-6(Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Contact Plating	Gold
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	SOT-23-6
Number of Pins	6
Operating Temperature	-40°C~85°C TA
Packaging	Tape & Reel (TR)
Published	2007
JESD-609 Code	e0
Pbfree Code	no
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	6
ECCN Code	EAR99
Resistance	45Ohm
Subcategory	Multiplexer or Switches
Max Power Dissipation	696mW
Technology	CMOS
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	240
Number of Functions	1
Supply Voltage	15V
Terminal Pitch	0.95mm
Time@Peak Reflow Temperature-Max (s)	20
Base Part Number	MAX4647
Pin Count	6
Operating Supply Voltage	20V
Polarity	Non-Inverting
Number of Channels	1
Number of Circuits	1
Max Supply Voltage	36V
Min Supply Voltage	9V
Operating Supply Current	20μA
Nominal Supply Current	150μA
Max Supply Current	100μA
Number of Bits	2
Throw Configuration	SPST
Turn On Delay Time	125 ns
Voltage - Supply, Single/Dual (±)	9V~36V ±4.5V~20V
Supply Type	Dual, Single
Neg Supply Voltage-Nom (Vsup)	-15V
Turn-Off Delay Time	125 ns
Max Dual Supply Voltage	20V
On-State Resistance (Max)	25Ohm
Min Dual Supply Voltage	4.5V
High Level Output Current	60mA
Dual Supply Voltage	15V
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	92 dB
Current - Leakage (IS(off)) (Max)	1nA
Channel Capacitance (CS(off), CD(off))	6pF 6pF
On-state Resistance Match-Nom	2Ohm
Switch Circuit	SPST - NC
Switch Time (Ton, Toff) (Max)	100ns, 100ns
Charge Injection	4pC
Channel-to-Channel Matching (ΔRon)	800m Ω
Switching	BREAK-BEFORE-MAKE
Normal Position	NC
Radiation Hardening	No
REACH SVHC	Unknown
RoHS Status	Non-RoHS Compliant
Lead Free	Contains Lead

MAX4647EUT-T Overview

Presented in SOT-23-6, this electrical component is convenient for overseas shipping. The advanced packaging method Tape & Reel (TR) provides high reliability. The multiplexer is located in Surface Mount. Multiplexers and demultiplexers have a ratio of 1:1. The operating temperature is extended to around -40°C~85°C TA. In total, there are 6 terminations. By its 1 channels, the electronic component provides high-quality output. It is safe to turn on and run the electronic component with a 15V voltage supply. This electronic part can be found in the 6 series. These analog multiplexers are built based on SPST - NC switching circuits. A 1 circuit is present in this switch device. Try searching with MAX4647 to find analog multiplexer variants. Internally, this switch multiplexer has a resistance of 45Ohm. Please refer to the datasheets for 6 pins functions. The analogue multiplexer in this example is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 36V. A analog switch ic that has a cost-effective Dual, Single supply type. There should be 9V voltage fed to the electrical part below 9V. An operating current of 20μA would be sufficient for this switch device. The switch multiplexer may be damaged if it is exposed to voltage greater than 100μA. If put voltage greater than 20V on the multiplexer, damage may be caused to the device. If you are using dual power supplies, you should attach at least 4.5V. 20V operating voltages can be used with this electrical part. It conducts in a 2-bit manner.