Parameters |
Factory Lead Time |
1 Week |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
SOT-23-6 |
Number of Pins |
6 |
Weight |
36.003894mg |
Operating Temperature |
-40°C~85°C TA |
Packaging |
Tape & Reel (TR) |
Published |
2007 |
JESD-609 Code |
e4 |
Pbfree Code |
yes |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
6 |
ECCN Code |
EAR99 |
Resistance |
25Ohm |
Terminal Finish |
Gold (Au) - with Nickel (Ni) barrier |
Subcategory |
Multiplexer or Switches |
Max Power Dissipation |
571mW |
Technology |
CMOS |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
1 |
Supply Voltage |
15V |
Terminal Pitch |
0.95mm |
Time@Peak Reflow Temperature-Max (s) |
30 |
Base Part Number |
MAX4648 |
Pin Count |
6 |
Operating Supply Voltage |
15V |
Number of Channels |
1 |
Number of Circuits |
1 |
Max Supply Voltage |
36V |
Min Supply Voltage |
9V |
Operating Supply Current |
1μA |
Nominal Supply Current |
10μA |
Max Supply Current |
100μA |
Number of Bits |
2 |
Throw Configuration |
SPST |
Turn On Delay Time |
60 ns |
Voltage - Supply, Single/Dual (±) |
9V~36V ±4.5V~20V |
Supply Type |
Dual, Single |
Neg Supply Voltage-Nom (Vsup) |
-15V |
Turn-Off Delay Time |
40 ns |
Max Dual Supply Voltage |
20V |
On-State Resistance (Max) |
25Ohm |
Min Dual Supply Voltage |
4.5V |
Dual Supply Voltage |
15V |
Multiplexer/Demultiplexer Circuit |
1:1 |
Off-state Isolation-Nom |
92 dB |
Current - Leakage (IS(off)) (Max) |
1nA |
Channel Capacitance (CS(off), CD(off)) |
6pF 6pF |
On-state Resistance Match-Nom |
2Ohm |
Switch Circuit |
SPST - NO |
Switch Time (Ton, Toff) (Max) |
100ns, 100ns |
Charge Injection |
4pC |
Channel-to-Channel Matching (ΔRon) |
800m Ω |
Switching |
BREAK-BEFORE-MAKE |
Drain to Source Resistance |
25Ohm |
Normal Position |
NO |
Height |
1.1mm |
Length |
2.9mm |
Width |
1.63mm |
Radiation Hardening |
No |
REACH SVHC |
Unknown |
RoHS Status |
ROHS3 Compliant |
Lead Free |
Lead Free |
MAX4648EUT+T Overview
This electronic part is conveniently packaged in SOT-23-6, making it easy to ship abroad. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). Surface Mount is where this multiplexer is located. There is 1:1 ratio between the number of multiplexers and demultiplexers. Operating temperature around -40°C~85°C TA extended. The total number of terminations is 6. High-quality output is provided by the electronic component's 1 channels. An 15V voltage supply should allow the electrical part to be turned on and run. There are 6 pins injected into the electronic part body. On the other hand, analog switches can be constructed using SPST - NO switching circuits. The circuits in this analogue multiplexer number 1. Try searching with MAX4648 if you're looking for variants. As far as internal resistance is concerned, it has 25Ohm. The datasheets for the 6 pins explain the functions. Multiplexer or Switches is a typical switch device. Users shouldn't supply more than 36V voltage to the switch device. An effective Dual, Single supply digital multiplexer. It is recommended that the electrical component receives a voltage of 9V. An operating current of 1μA would be sufficient for this switch device. The analogue multiplexer may be damaged if voltage is greater than 100μA. If put voltage greater than 20V on the multiplexer, damage may be caused to the device. When using dual power supplies, you should attach at least 4.5V. The electrical part can be operated at 15V voltage levels. There is 25Ohm resistance between the Drain and Source on this part. It is capable of carrying out 2-bit operation.
MAX4648EUT+T Features
1 Channels
Switch Circuit: SPST - NO
1μA Supply Current
Drain-to-Source resistance: 25Ohm
2-Bit
MAX4648EUT+T Applications
There are a lot of Maxim Integrated MAX4648EUT+T Analog Switches & Multiplexers ICs applications.
- Automatic test equipment
- Relay replacements
- New designs requiring multiplexer functions
- Audio and video signal routing
- Digital access cross connects
- Audio and video routing
- Public switching systems
- DSLAMs
- 65 V DACs
- USB 1.1 signal switching circuits