MAX4649EKA+T

SPDT 45Ohm Analog Switches MAX4649 8 Pins 2nA 15V SOT-23-8

Manufacturer: Maxim Integrated
Nocochips NO: 503-MAX4649EKA+T
Package: SOT-23-8
Datasheet: PDF
Stock: 625
Description: SPDT 45Ohm Analog Switches MAX4649 8 Pins 2nA 15V SOT-23-8(Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Contact Plating	Gold
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	SOT-23-8
Number of Pins	8
Operating Temperature	-40°C~85°C TA
Packaging	Tape & Reel (TR)
Published	2001
JESD-609 Code	e4
Pbfree Code	yes
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	8
ECCN Code	EAR99
Resistance	45Ohm
Additional Feature	CAN ALSO OPERATE FROM SINGLE SUPPLY OF 9V TO 36V
Max Power Dissipation	714mW
Technology	CMOS
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	1
Supply Voltage	15V
Terminal Pitch	0.65mm
Time@Peak Reflow Temperature-Max (s)	30
Base Part Number	MAX4649
Pin Count	8
Operating Supply Voltage	20V
Polarity	Non-Inverting
Number of Channels	1
Number of Circuits	1
Max Supply Voltage	36V
Min Supply Voltage	9V
Operating Supply Current	1μA
Nominal Supply Current	38μA
Max Supply Current	75μA
Number of Bits	2
Turn On Delay Time	130 ns
Voltage - Supply, Single/Dual (±)	9V~36V ±4.5V~20V
Supply Type	Dual, Single
Neg Supply Voltage-Nom (Vsup)	-15V
Turn-Off Delay Time	130 ns
Max Dual Supply Voltage	20V
On-State Resistance (Max)	45Ohm
Min Dual Supply Voltage	4.5V
High Level Output Current	30mA
Multiplexer/Demultiplexer Circuit	2:1
Off-state Isolation-Nom	92 dB
Current - Leakage (IS(off)) (Max)	2nA
Channel Capacitance (CS(off), CD(off))	6pF
On-state Resistance Match-Nom	5Ohm
Switch Circuit	SPDT
Charge Injection	2pC
Channel-to-Channel Matching (ΔRon)	600m Ω
Crosstalk	-92dB @ 1MHz
Drain to Source Resistance	45Ohm
Height	1.3mm
Length	3mm
Width	1.75mm
Radiation Hardening	No
REACH SVHC	No SVHC
RoHS Status	ROHS3 Compliant
Lead Free	Lead Free

MAX4649EKA+T Overview

Presented in SOT-23-8, this electrical component is convenient for overseas shipping. High reliability is provided by advanced packaging method Tape & Reel (TR). Multiplexers like this are mounted in the Surface Mount position. 2:1 is the ratio of multiplexer to demultiplexer circuits. Operating temperature extended to -40°C~85°C TA. A total of 8 terminations have been recorded. Due to its 1 channels, the electrical component produces high-quality output. In the case of a voltage supply of 15V volts, the electrical part can be powered up and run. Electronic part bodies are injected with 8 pins. Unlike digital switches, these are based on SPDT switching circuits. The circuits in this analogue multiplexer number 1. Try searching with MAX4649 to find analog multiplexer variants. An switch multiplexer with 45Ohm internal resistance has a value of 45Ohm. The datasheets for the 8 pins explain the functions. Multiplexers should not be powered above 36V in normal situations. Dual, Single supply type digital switch with a low cost. 9V is the lowest voltage the electrical component should receive. It would be sufficient to run this analogue multiplexer with 1μA current. The analogue multiplexer may be damaged if voltage is greater than 75μA. For this switch, a dual supply voltage is feasible, but it must not exceed 20VFor dual power supplies, a voltage of at least 4.5V should be attached. There is a voltage range of 20V operating voltages for the electrical part. You shouldn't miss the additional features of the electrical component, such as: CAN ALSO OPERATE FROM SINGLE SUPPLY OF 9V TO 36V. A Drain to Source resistance of 45Ohm is shown for this electronic part. Its conductivity is 2-bit.

MAX4649EKA+T Features

1 Channels
Switch Circuit: SPDT
1μA Supply Current
Additional Features: CAN ALSO OPERATE FROM SINGLE SUPPLY OF 9V TO 36V
Drain-to-Source resistance: 45Ohm
2-Bit