MAX4661CPE
| Parameters | |
|---|---|
| Mounting Type | Through Hole |
| Package / Case | 16-DIP (0.300, 7.62mm) |
| Surface Mount | NO |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| Terminal Finish | TIN LEAD |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Pin Count | 16 |
| JESD-30 Code | R-PDIP-T16 |
| Qualification Status | COMMERCIAL |
| Number of Channels | 1 |
| Number of Circuits | 4 |
| Voltage - Supply, Single/Dual (±) | 4.5V~36V ±4.5V~20V |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| On-State Resistance (Max) | 2.5Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 56 dB |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 55pF 55pF |
| On-state Resistance Match-Nom | 0.1Ohm |
| Switch Circuit | SPST - NC |
| Switch Time (Ton, Toff) (Max) | 275ns, 175ns |
| Charge Injection | 300pC |
| Channel-to-Channel Matching (ΔRon) | 100m Ω |
| Crosstalk | -59dB @ 1MHz |
| Switch-on Time-Max | 275ns |
| Switch-off Time-Max | 175ns |
| Length | 19.175mm |
| Width | 7.62mm |
| RoHS Status | Non-RoHS Compliant |
MAX4661CPE Overview
The electronic component is convenient to ship overseas because it is packed in a 16-DIP (0.300, 7.62mm). To ensure high reliability, a new packaging method Tube is used. It is mounted in the position Through Hole. 1:1 is the ratio between multiplexers and demultiplexers. Operating temperature around 0°C~70°C TA extended. 16 terminations have been made so far. The electronic part provides high-quality output because it has 1 channels. If the voltage supply is 15V volts, the electrical component should be turned on and run. It is part of the design of the 16 series that this electronic component is included. A SPST - NC switching circuit is used to build these analog multiplexers. 4 circuits are used in this analogue multiplexer.
MAX4661CPE Features
1 Channels
Switch Circuit: SPST - NC
MAX4661CPE Applications
There are a lot of Rochester Electronics, LLC MAX4661CPE Analog Switches & Multiplexers ICs applications.
- Video signal routing
- ISDN NT1/TA
- SONET
- Power routing
- Microwave transmission systems
- FTTH
- SDH
- Low-Voltage
- Access Concentrators
- Remote Powered Equipment
