MAX4661EWE

275ns, 175ns SPST - NC 2.5Ohm Analog Switches BREAK-BEFORE-MAKE MAX4661 16 Pins 500pA 15V 16-SOIC (0.295, 7.50mm Width)

Manufacturer: Maxim Integrated
Nocochips NO: 503-MAX4661EWE
Package: 16-SOIC (0.295, 7.50mm Width)
Datasheet: PDF
Stock: 674
Description: 275ns, 175ns SPST - NC 2.5Ohm Analog Switches BREAK-BEFORE-MAKE MAX4661 16 Pins 500pA 15V 16-SOIC (0.295, 7.50mm Width)(Kg)

Details

Tags

Parameters
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	16-SOIC (0.295, 7.50mm Width)
Number of Pins	16
Operating Temperature	-40°C~85°C TA
Packaging	Tube
Published	1999
JESD-609 Code	e0
Pbfree Code	no
Part Status	Obsolete
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	16
ECCN Code	EAR99
Resistance	2.5Ohm
Terminal Finish	Tin/Lead (Sn85Pb15)
Subcategory	Multiplexer or Switches
Max Power Dissipation	571mW
Technology	CMOS
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	240
Number of Functions	4
Supply Voltage	15V
Terminal Pitch	1.27mm
Time@Peak Reflow Temperature-Max (s)	20
Base Part Number	MAX4661
Output	SEPARATE OUTPUT
Pin Count	16
Operating Supply Voltage	20V
Power Supplies	12/+-15V
Number of Channels	1
Number of Circuits	4
Max Supply Voltage	36V
Min Supply Voltage	4.5V
Nominal Supply Current	1nA
Max Supply Current	1nA
Throw Configuration	SPST
Turn On Delay Time	275 ns
Voltage - Supply, Single/Dual (±)	4.5V~36V ±4.5V~20V
Supply Type	Dual, Single
Neg Supply Voltage-Nom (Vsup)	-15V
Turn-Off Delay Time	175 ns
Max Dual Supply Voltage	20V
On-State Resistance (Max)	2.5Ohm
Min Dual Supply Voltage	4.5V
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	56 dB
Current - Leakage (IS(off)) (Max)	500pA
Channel Capacitance (CS(off), CD(off))	55pF 55pF
On-state Resistance Match-Nom	0.1Ohm
Switch Circuit	SPST - NC
Switch Time (Ton, Toff) (Max)	275ns, 175ns
Charge Injection	300pC
Channel-to-Channel Matching (ΔRon)	100m Ω
Crosstalk	-59dB @ 1MHz
Switching	BREAK-BEFORE-MAKE
Normal Position	NO
Height Seated (Max)	2.65mm
Length	10.3mm
Width	7.5mm
Radiation Hardening	No
RoHS Status	Non-RoHS Compliant

MAX4661EWE Overview

Shipping overseas is convenient with the electronic component packed in 16-SOIC (0.295, 7.50mm Width). A high level of reliability can be achieved through the use of an advanced packaging method Tube. A switch device like this is mounted in Surface Mount. 1:1 is the number of circuits in the multiplexer and demultiplexer. Increasing operating temperature to around -40°C~85°C TA. There are 16 terminations totally. A 1 channel electronic part produces high-quality output. Powered by a 15V voltage supply, the electrical part should be switched on and run. As part of the design of the 16 series, this electronic part has been incorporated into the system. Circuits based on SPST - NC switching are used to construct these analog switch ics. There are 4 circuits in this multiplexer. Try searching with MAX4661 if you're looking for variants. This digital multiplexer has 2.5Ohm internal resistance. Please refer to the datasheets for 16 pins functions. A analogue multiplexer of this type is a Multiplexer or Switches. It is generally not recommended to supply a voltage higher than 36V to the switch device in normal circumstances. Dual, Single supply type digital switch with a low cost. 4.5V is the lowest voltage that should be fed to the electronic electronic part. A voltage higher than 1nA may cause damage to the switch multiplexer. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 20V. A dual power supply should have at least 4.5V voltage attached. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. 20V operating voltages can be used with this electrical part.