Parameters |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
16-SOIC (0.154, 3.90mm Width) |
Number of Pins |
16 |
Operating Temperature |
-40°C~85°C TA |
Packaging |
Tube |
Published |
1999 |
JESD-609 Code |
e0 |
Pbfree Code |
no |
Part Status |
Obsolete |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
16 |
ECCN Code |
EAR99 |
Resistance |
4Ohm |
Terminal Finish |
Tin/Lead (Sn85Pb15) |
Subcategory |
Multiplexer or Switches |
Max Power Dissipation |
696mW |
Technology |
CMOS |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
240 |
Number of Functions |
4 |
Supply Voltage |
15V |
Terminal Pitch |
1.27mm |
Time@Peak Reflow Temperature-Max (s) |
20 |
Base Part Number |
MAX4664 |
Output |
SEPARATE OUTPUT |
Pin Count |
16 |
Operating Supply Voltage |
20V |
Number of Channels |
4 |
Max Supply Voltage |
36V |
Min Supply Voltage |
4.5V |
Nominal Supply Current |
5μA |
Max Supply Current |
500nA |
Throw Configuration |
SPST |
Turn On Delay Time |
250 ns |
Voltage - Supply, Single/Dual (±) |
4.5V~36V ±4.5V~20V |
Supply Type |
Dual, Single |
Neg Supply Voltage-Nom (Vsup) |
-15V |
Turn-Off Delay Time |
400 ns |
Max Dual Supply Voltage |
20V |
On-State Resistance (Max) |
4Ohm |
Min Dual Supply Voltage |
4.5V |
Multiplexer/Demultiplexer Circuit |
1:1 |
Off-state Isolation-Nom |
62 dB |
Current - Leakage (IS(off)) (Max) |
500pA |
Channel Capacitance (CS(off), CD(off)) |
34pF 34pF |
On-state Resistance Match-Nom |
0.2Ohm |
Switch Circuit |
SPST - NC |
Switch Time (Ton, Toff) (Max) |
275ns, 175ns |
Charge Injection |
300pC |
Channel-to-Channel Matching (ΔRon) |
200m Ω |
Crosstalk |
-60dB @ 1MHz |
Switching |
BREAK-BEFORE-MAKE |
Switch-on Time-Max |
275ns |
Switch-off Time-Max |
175ns |
Normal Position |
NO |
Height Seated (Max) |
1.75mm |
Length |
9.9mm |
Width |
3.9mm |
Radiation Hardening |
No |
REACH SVHC |
Unknown |
RoHS Status |
Non-RoHS Compliant |
Lead Free |
Contains Lead |
MAX4664ESE Overview
Shipping overseas is convenient with the electronic component packed in 16-SOIC (0.154, 3.90mm Width). The advanced packaging method Tube provides high reliability. In Surface Mount, this analog switch is mounted. 1:1 is the ratio of multiplexer to demultiplexer circuits. Operating temperature extended to -40°C~85°C TA. The total number of terminations is 16. The electronic part delivers high-quality output through its 4 channels. With a 15V voltage supply, the electrical component should be turned on and run. It is part of the design of the 16 series that this electronic component is included. On the other hand, analog switches can be constructed using SPST - NC switching circuits. Try searching with MAX4664 to find analog multiplexer variants. In this multiplexer, the internal resistance is 4Ohm. Datasheets for functions of 16 pins are available. The analogue multiplexer in this example is a typical Multiplexer or Switches. Multiplexers should not be powered above 36V in normal situations. Digital switch that provides Dual, Single power at a cost-effective price. A low voltage of 4.5V should be applied to the electronic component. Put voltage above 500nA on the multiplexer to cause damage. There is no problem with using dual supply voltage, but it should not exceed 20V. With dual power supplies, you should attach at least 4.5V. The outputs of this digital multiplexer are SEPARATE OUTPUT in number. Operating voltages of 20V are compatible with the electrical part.
MAX4664ESE Features
4 Channels
Switch Circuit: SPST - NC
MAX4664ESE Applications
There are a lot of Maxim Integrated MAX4664ESE Analog Switches & Multiplexers ICs applications.
- Mechanical reed relay replacement
- Audio/video switches
- Voice over IP/DSL – Integrated Access Devices, Smart
- PDAs
- ISDN NT1/TA
- PBXs
- SONET/SDH ADM
- Automotive applications
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- Frame Relay Equipment