MAX4665CSE
| Parameters | |
|---|---|
| Contact Plating | Tin |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 16 |
| Weight | 665.986997mg |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Published | 1999 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 4Ohm |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 696mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Terminal Pitch | 1.27mm |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Base Part Number | MAX4665 |
| Pin Count | 16 |
| Polarity | Non-Inverting |
| Number of Channels | 4 |
| Max Supply Voltage | 36V |
| Min Supply Voltage | 4.5V |
| Max Supply Current | 500nA |
| Throw Configuration | SPST |
| Turn On Delay Time | 275 ns |
| Voltage - Supply, Single/Dual (±) | 4.5V~36V ±4.5V~20V |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 175 ns |
| Max Dual Supply Voltage | 20V |
| On-State Resistance (Max) | 4Ohm |
| Min Dual Supply Voltage | 4.5V |
| High Level Output Current | 100mA |
| Dual Supply Voltage | 15V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 62 dB |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 34pF 34pF |
| On-state Resistance Match-Nom | 0.2Ohm |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 275ns, 175ns |
| Charge Injection | 300pC |
| Channel-to-Channel Matching (ΔRon) | 200m Ω |
| Crosstalk | -60dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Normal Position | NC |
| Height | 1.5mm |
| Length | 10mm |
| Width | 4mm |
| Radiation Hardening | No |
| REACH SVHC | Unknown |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
MAX4665CSE Overview
Presented in 16-SOIC (0.154, 3.90mm Width), this electrical component is convenient for overseas shipping. High reliability is ensured by the advanced packaging method Tube. It is mounted in the position Surface Mount. Multiplexer and demultiplexer circuits have a number 1:1. Increasing operating temperature to around 0°C~70°C TA. There are 16 terminations totally. High-quality output is provided by the electronic component's 4 channels. With a 15V voltage supply, the electrical component should be turned on and run. As part of its design, the 16 series is equipped with this electronic component. SPST - NO switching circuits are used in these analog switch ics. Try searching for the analog switch ic with MAX4665 if you are looking for variants. It has an internal resistance of 4Ohm. You can find the functions of the 16 pins in the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. It is generally not recommended to supply a voltage higher than 36V to the switch device in normal circumstances. Analog switch ics with Dual, Single supply type are cost-effective. In order for the electronic part to function properly, the lowest voltage should be 4.5V. When the digital multiplexer is charged above 500nA, damage can occur. Dual supply volatge is feasible for this multiplexer. But it should not go beyond 20V. If you are using a dual power supply, you should attach at least 4.5V.
MAX4665CSE Features
4 Channels
Switch Circuit: SPST - NO
MAX4665CSE Applications
There are a lot of Maxim Integrated MAX4665CSE Analog Switches & Multiplexers ICs applications.
- Switching Systems
- High speed data transmission line cards
- CSU
- Multi-Line E1 Interface Cards
- Automatic test equipment
- Remote Powered Equipment
- T1/E1 Terminals
- Medical systems
- PDH Multiplexers
- Battery Powered Instruments
