MAX4678EUE+T
| Parameters | |
|---|---|
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 842mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX4678 |
| Pin Count | 16 |
| Operating Supply Voltage | 5.5V |
| Polarity | Non-Inverting |
| Power Supplies | 2.7/5/+-5V |
| Number of Channels | 1 |
| Number of Circuits | 4 |
| Max Supply Voltage | 11V |
| Min Supply Voltage | 2.7V |
| Nominal Supply Current | 1μA |
| Max Supply Current | 1nA |
| Throw Configuration | SPST |
| Turn On Delay Time | 165 ns |
| Voltage - Supply, Single/Dual (±) | 2.7V~11V ±2.7V~5.5V |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Turn-Off Delay Time | 1 μs |
| Max Dual Supply Voltage | 5.5V |
| -3db Bandwidth | 66MHz |
| On-State Resistance (Max) | 1.6Ohm |
| Min Dual Supply Voltage | 2.7V |
| High Level Output Current | 100mA |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 65 dB |
| Channel Capacitance (CS(off), CD(off)) | 85pF 85pF |
| On-state Resistance Match-Nom | 0.2Ohm |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 350ns, 150ns |
| Charge Injection | 85pC |
| Channel-to-Channel Matching (ΔRon) | 200m Ω |
| Crosstalk | -84dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 350ns |
| Switch-off Time-Max | 150ns |
| Normal Position | NO |
| Height Seated (Max) | 1.1mm |
| Length | 5mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Factory Lead Time | 1 Week |
| Contact Plating | Tin |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Number of Pins | 16 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2000 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 1.6Ohm |
MAX4678EUE+T Overview
The electrical component comes in 16-TSSOP (0.173, 4.40mm Width) packaging, which makes it convenient to ship overseas. Advanced packaging method Tape & Reel (TR) is used to provide high reliability. In Surface Mount, this analog switch is mounted. 1:1 is the ratio between multiplexers and demultiplexers. Increasing operating temperature to around -40°C~85°C TA. There are 16 terminations totally. This electronic part offers high-quality output due to its 1 channels. In the case of a voltage supply of 5V volts, the electrical part can be powered up and run. This electrical component is included in the 16 series of products. A SPST - NO switching circuit is used for these analog switches. It consists of 4 circuits. Try searching for MAX4678 variants of the analog switch ic. A 1.6Ohm internal resistance characterizes this multiplexer. The functions of 16 pins can be found in the datasheets. In this analog multiplexer, the value is Multiplexer or Switches. normally, users should not supply switches with voltages higher than 11V. Analogue multiplexer with a Dual, Single supply type that is cost-effective. There should be 2.7V voltage fed to the electrical part below 2.7V. Put voltage above 1nA on the multiplexer to cause damage. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 5.5V. With dual power supplies, you should attach at least 2.7V. The electrical part can be operated at 5.5V voltage levels.
MAX4678EUE+T Features
1 Channels
Switch Circuit: SPST - NO
-3db Bandwidth: 66MHz
MAX4678EUE+T Applications
There are a lot of Maxim Integrated MAX4678EUE+T Analog Switches & Multiplexers ICs applications.
- Sample hold systems
- Industrial
- Residential Gateways, Home Gateway/Router
- Remote wireless modules
- Sample-and-hold systems
- SONET
- Channel Banks
- T1/E1 Terminals
- ADCs such as AD7840/8, AD7870/1/2/4/5/6/8
- Automotive applications
