MAX4679EUE+T
| Parameters | |
|---|---|
| Nominal Supply Current | 1μA |
| Max Supply Current | 1μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 500 ns |
| Voltage - Supply, Single/Dual (±) | 2.7V~11V ±2.7V~5.5V |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Turn-Off Delay Time | 350 ns |
| Max Dual Supply Voltage | 5.5V |
| -3db Bandwidth | 66MHz |
| On-State Resistance (Max) | 1.6Ohm |
| Min Dual Supply Voltage | 2.7V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 65 dB |
| Current - Leakage (IS(off)) (Max) | 1nA |
| Channel Capacitance (CS(off), CD(off)) | 85pF 85pF |
| On-state Resistance Match-Nom | 0.2Ohm |
| Switch Circuit | SPST - NO/NC |
| Switch Time (Ton, Toff) (Max) | 350ns, 150ns |
| Charge Injection | 85pC |
| Channel-to-Channel Matching (ΔRon) | 200m Ω |
| Crosstalk | -84dB @ 1MHz |
| Switch-off Time-Max | 150ns |
| Height Seated (Max) | 1.1mm |
| Length | 5mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Number of Pins | 16 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2000 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 1.6Ohm |
| Terminal Finish | Matte Tin (Sn) |
| Max Power Dissipation | 457mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX4679 |
| Pin Count | 16 |
| Operating Supply Voltage | 5V |
| Number of Channels | 1 |
| Number of Circuits | 4 |
| Max Supply Voltage | 11V |
| Min Supply Voltage | 2.7V |
MAX4679EUE+T Overview
Packed in 16-TSSOP (0.173, 4.40mm Width), the electronic component is convenient for shipping overseas. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. Mounted in Surface Mount is this multiplexer. 1:1 is the ratio between multiplexers and demultiplexers. Operational temperature extended around -40°C~85°C TA. There are 16 terminations totally. A high-quality output is provided by the electrical component's 1 channels. A 5V voltage supply should turn on and run the electronic component. An electrical component like this is included in the 16 series. The analog switch ics are built using SPST - NO/NC switching circuits. The circuits in this analogue multiplexer number 4. Look for analog switch ic variants by searching with MAX4679. As far as internal resistance is concerned, it has 1.6Ohm. The datasheets for the 16 pins explain the functions. In a normalsituation, users should not supply the switches with voltage higher than 11V. Analogue multiplexer with a Dual, Single supply type that is cost-effective. The lowest voltage the electronic part should receive is 2.7V. It may damage the digital multiplexer if the voltage is higher than 1μA. For this multiplexer, dual supply voltage is feasible, but it should not exceed 5.5V. For dual power supplies, a voltage of at least 2.7V should be attached. 5V operating voltages are supported by the electronic component.
MAX4679EUE+T Features
1 Channels
Switch Circuit: SPST - NO/NC
-3db Bandwidth: 66MHz
MAX4679EUE+T Applications
There are a lot of Maxim Integrated MAX4679EUE+T Analog Switches & Multiplexers ICs applications.
- Signal routing between systems
- Video switching
- High-Voltage
- FTTH
- Medical Instrumentation
- PBXs
- Communication systems
- Microprocessor controlled systems
- Low-Voltage
- Mechanical reed relay replacement
