MAX4680EAE
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SSOP (0.209, 5.30mm Width) |
| Number of Pins | 16 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 1999 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 1.25Ohm |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 571mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 245 |
| Number of Functions | 2 |
| Supply Voltage | 15V |
| Terminal Pitch | 0.65mm |
| Base Part Number | MAX4680 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Number of Channels | 2 |
| Max Supply Voltage | 20V |
| Min Supply Voltage | 4.5V |
| Nominal Supply Current | 10nA |
| Max Supply Current | 500nA |
| Throw Configuration | SPST |
| Turn On Delay Time | 275 ns |
| Voltage - Supply, Single/Dual (±) | 4.5V~36V ±4.5V~20V |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 175 ns |
| Max Dual Supply Voltage | 20V |
| On-State Resistance (Max) | 1.25Ohm |
| Min Dual Supply Voltage | 4.5V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 53 dB |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 115pF 115pF |
| On-state Resistance Match-Nom | 0.09Ohm |
| Switch Circuit | SPST - NC |
| Switch Time (Ton, Toff) (Max) | 275ns, 175ns |
| Charge Injection | 55pC |
| Channel-to-Channel Matching (ΔRon) | 90m Ω |
| Crosstalk | -65dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 400ns |
| Switch-off Time-Max | 300ns |
| Normal Position | NO |
| Height | 1.78mm |
| Length | 6.33mm |
| Width | 5.38mm |
| Radiation Hardening | No |
| REACH SVHC | Unknown |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
MAX4680EAE Overview
Packed in 16-SSOP (0.209, 5.30mm Width), the electronic component is convenient for shipping overseas. High reliability is provided by advanced packaging method Tube. A switch device like this is mounted in Surface Mount. There is 1:1 ratio between the number of multiplexers and demultiplexers. Operating temperature around -40°C~85°C TA extended. Total terminations are 16. This electronic part offers high-quality output due to its 2 channels. It is safe to turn on and run the electronic component with a 15V voltage supply. It is injected into the electrical part body with 16 pins. Based on SPST - NC switching circuits, these analog multiplexers work. MAX4680 can be used to search for analog multiplexer variants. This digital multiplexer has 1.25Ohm internal resistance. The functions of 16 pins can be found in the datasheets. This switch device is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 20V. Dual, Single supply type digital switch with a low cost. It is recommended to use 4.5V as the lowest voltage for the electrical part. Put voltage above 500nA on the multiplexer to cause damage. If put voltage greater than 20V on the multiplexer, damage may be caused to the device. If you are using dual power supplies, you should attach at least 4.5V. As far as the outputs go, this switch multiplexer utilizes SEPARATE OUTPUT of them.
MAX4680EAE Features
2 Channels
Switch Circuit: SPST - NC
MAX4680EAE Applications
There are a lot of Maxim Integrated MAX4680EAE Analog Switches & Multiplexers ICs applications.
- Wireless Local Loop
- Channelized and Unchannelized DS3 applications
- PCMCIA cards
- Battery Powered Instruments
- Industrial and process control systems
- CSU
- Precision test equipment
- Cell phones
- Industrial control systems
- Video signal routing
