MAX4694ETE+
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 16-WQFN Exposed Pad |
| Surface Mount | YES |
| Number of Pins | 16 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2012 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 70Ohm |
| Terminal Finish | MATTE TIN |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | QUAD |
| Peak Reflow Temperature (Cel) | 225 |
| Number of Functions | 4 |
| Terminal Pitch | 0.635mm |
| Base Part Number | MAX4694 |
| Output | SEPARATE OUTPUT |
| Power Supplies | 3/5V |
| Number of Circuits | 4 |
| Max Supply Voltage | 11V |
| Min Supply Voltage | 2V |
| Voltage - Supply, Single/Dual (±) | 2.7V~11V ±2V~5.5V |
| Max Dual Supply Voltage | 5.5V |
| On-State Resistance (Max) | 70Ohm |
| Min Dual Supply Voltage | 2V |
| Multiplexer/Demultiplexer Circuit | 2:1 |
| Current - Leakage (IS(off)) (Max) | 1nA |
| Switch Circuit | SPDT |
| Charge Injection | 0.1pC |
| Channel-to-Channel Matching (ΔRon) | 2 Ω |
| Crosstalk | -75dB @ 100kHz |
| Switching | BREAK-BEFORE-MAKE |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
MAX4694ETE+ Overview
Shipping overseas is convenient with the electronic component packed in 16-WQFN Exposed Pad. This packaging method provides high reliability because it uses advanced packaging techniques. The multiplexer is located in Surface Mount. Multiplexers and demultiplexers have the same number of circuits 2:1. The operating temperature is extended to around -40°C~85°C TA. In total, there have been 16 terminations. Unlike digital switches, these are based on SPDT switching circuits. This multiplexer is composed of 4 circuits. Try searching with MAX4694 to find analog multiplexer variants. Analog switches have 70Ohm internal resistance. The functions of 16 pins can be found in the datasheets. Theswitch device is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 11V. It is recommended to use 2V as the lowest voltage for the electrical part. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 5.5V. It is recommended that you attach at least 2V to your dual power supply. SEPARATE OUTPUT outputs are utilized by this digital multiplexer.
MAX4694ETE+ Features
Switch Circuit: SPDT
MAX4694ETE+ Applications
There are a lot of Maxim Integrated MAX4694ETE+ Analog Switches & Multiplexers ICs applications.
- Battery-powered systems
- Intelligent PBX
- Industrial and process control systems
- Digital cross connects (DSX-1)
- FTTH
- Wireless Local Loop
- PBXs
- Switching Systems
- PDAs
- Frame Relay Equipment
