MAX4700CPE+
| Parameters | |
|---|---|
| Package / Case | DIP |
| Surface Mount | NO |
| Number of Pins | 16 |
| Published | 1999 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 1.25Ohm |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | THROUGH-HOLE |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 2 |
| Supply Voltage | 15V |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Temperature Grade | COMMERCIAL |
| Number of Channels | 1 |
| Number of Circuits | 2 |
| Max Supply Voltage | 36V |
| Min Supply Voltage | 4.5V |
| Analog IC - Other Type | SPST |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Max Dual Supply Voltage | 20V |
| Min Dual Supply Voltage | 4.5V |
| Off-state Isolation-Nom | 53 dB |
| On-state Resistance Match-Nom | 0.09Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 400ns |
| Switch-off Time-Max | 300ns |
| Length | 19.175mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
MAX4700CPE+ Overview
As the electronic part is packed in DIP, international shipping is convenient. A total of 16 terminations have been recorded. By its 1 channels, the electronic component provides high-quality output. Powered by a 15V voltage supply, the electrical part should be switched on and run. There is an electrical component included in the 16 series. It consists of 2 circuits. There is 1.25Ohm internal resistance in this digital multiplexer. For functions related to 16 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 36V. It is recommended to use 4.5V as the lowest voltage for the electrical part. There is no problem with using dual supply voltage, but it should not exceed 20V. In the case of dual power supplies, you should connect at least 4.5V. It is integrated with a SPST analog IC. There are SEPARATE OUTPUT outputs on this analog switch ic. Temperatures above 70°C should not be used to operate the switches.
MAX4700CPE+ Features
1 Channels
MAX4700CPE+ Applications
There are a lot of Maxim Integrated MAX4700CPE+ Analog Switches & Multiplexers ICs applications.
- Avionics and Military Systems
- Relay replacements
- Medical systems
- RGB switches
- SDH
- Wireless Local Loop
- Residential Gateways, Home Gateway/Router
- Multi-Line E1 Interface Cards
- Mechanical reed relay replacement
- Precision data acquisition
