MAX4713EUE

125ns, 80ns SPST - NO/NC 25Ohm Analog Switches BREAK-BEFORE-MAKE MAX4713 16 Pins 500pA 5V 16-TSSOP (0.173, 4.40mm Width)

Manufacturer: Maxim Integrated
Nocochips NO: 503-MAX4713EUE
Package: 16-TSSOP (0.173, 4.40mm Width)
Datasheet: PDF
Stock: 181
Description: 125ns, 80ns SPST - NO/NC 25Ohm Analog Switches BREAK-BEFORE-MAKE MAX4713 16 Pins 500pA 5V 16-TSSOP (0.173, 4.40mm Width)(Kg)

Inquiry Now

Details

Tags

Parameters
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	16-TSSOP (0.173, 4.40mm Width)
Number of Pins	16
Operating Temperature	-40°C~85°C TA
Packaging	Tube
Published	2004
JESD-609 Code	e0
Pbfree Code	no
Part Status	Obsolete
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	16
ECCN Code	EAR99
Resistance	25Ohm
Terminal Finish	Tin/Lead (Sn85Pb15)
Additional Feature	CAN ALSO OPERATE FROM SINGLE SUPPLY OF 2.7V TO 11V
Subcategory	Multiplexer or Switches
Max Power Dissipation	475mW
Technology	CMOS
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	240
Number of Functions	4
Supply Voltage	5V
Terminal Pitch	0.65mm
Time@Peak Reflow Temperature-Max (s)	20
Base Part Number	MAX4713
Output	SEPARATE OUTPUT
Pin Count	16
Power Supplies	3/5/+-5V
Number of Channels	1
Number of Circuits	4
Max Supply Voltage	11V
Min Supply Voltage	2.7V
Nominal Supply Current	34μA
Max Supply Current	75μA
Throw Configuration	SPST
Turn On Delay Time	150 ns
Voltage - Supply, Single/Dual (±)	2.7V~11V ±2.7V~5.5V
Supply Type	Dual, Single
Neg Supply Voltage-Nom (Vsup)	-5V
Turn-Off Delay Time	100 ns
Max Dual Supply Voltage	5.5V
On-State Resistance (Max)	25Ohm
Min Dual Supply Voltage	2.7V
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	59 dB
Current - Leakage (IS(off)) (Max)	500pA
Channel Capacitance (CS(off), CD(off))	8pF 8pF
On-state Resistance Match-Nom	0.2Ohm
Switch Circuit	SPST - NO/NC
Switch Time (Ton, Toff) (Max)	125ns, 80ns
Charge Injection	25pC
Channel-to-Channel Matching (ΔRon)	200m Ω
Crosstalk	-87dB @ 1MHz
Switching	BREAK-BEFORE-MAKE
Switch-on Time-Max	125ns
Switch-off Time-Max	80ns
Height Seated (Max)	1.1mm
Length	5mm
Radiation Hardening	No
RoHS Status	Non-RoHS Compliant
Lead Free	Contains Lead

MAX4713EUE Overview

As the electronic part is packed in 16-TSSOP (0.173, 4.40mm Width), international shipping is convenient. To ensure high reliability, a new packaging method Tube is used. In Surface Mount, you'll find this switch device. 1:1 is the ratio of multiplexer to demultiplexer circuits. Extended operating temperature around -40°C~85°C TA. In total, there have been 16 terminations. A 1 channel electronic part produces high-quality output. An 5V voltage supply should allow the electrical part to be turned on and run. A total of 16 pins are injected into the electrical part body. The analog switch ics are built using SPST - NO/NC switching circuits. The circuits in this analogue multiplexer number 4. Look for analog switch ic variants by searching with MAX4713. In this multiplexer, the internal resistance is 25Ohm. Datasheets for 16 pin functions are available upon request. This switch device is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 11V. Analogue multiplexers of the Dual, Single supply type that are cost-effective. 2.7V should be the lowest voltage fed to the electronic component. Put voltage above 75μA on the multiplexer to cause damage. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 5.5V. You should attach at least 2.7V voltage if you are using dual power supply. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. Don't miss this electronic component's additional features, such as: CAN ALSO OPERATE FROM SINGLE SUPPLY OF 2.7V TO 11V.