MAX4717ETB+T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Tin |
| Mount | Surface Mount |
| Number of Pins | 10 |
| Packaging | Strip |
| Published | 2005 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 10 |
| ECCN Code | EAR99 |
| Resistance | 4.5Ohm |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Max Power Dissipation | 444mW |
| Technology | BICMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 10 |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Number of Circuits | 2 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.8V |
| Operating Supply Current | 1μA |
| Max Supply Current | 1μA |
| Throw Configuration | SPDT |
| Turn On Delay Time | 80 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 40 ns |
| -3db Bandwidth | 300MHz |
| High Level Output Current | 100mA |
| Off-state Isolation-Nom | 55 dB |
| On-state Resistance Match-Nom | 0.1Ohm |
| Height Seated (Max) | 0.8mm |
| Length | 3mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
MAX4717ETB+T Overview
High reliability is ensured by the advanced packaging method Strip. In total, 10 terminations have occurred. The electronic part provides high-quality output because it has 1 channels. In the case of a voltage supply of 3V volts, the electrical part can be powered up and run. A key feature of the 10 series is the inclusion of this electronic part as part of its design. The multiplexer consists of 2 circuits. In this multiplexer, the internal resistance is 4.5Ohm. You can find the functions of the 10 pins in the datasheets. Multiplexers should not be powered above 5.5V in normal situations. Analogue multiplexer with a Single supply type that is cost-effective. In order for the electronic part to function properly, the lowest voltage should be 1.8V. This multiplexer would work with 1μA current. The analogue multiplexer may be damaged if voltage is greater than 1μA. Temperatures higher than 85°C are not recommended for operation of the analogue multiplexer.
MAX4717ETB+T Features
1 Channels
1μA Supply Current
-3db Bandwidth: 300MHz
MAX4717ETB+T Applications
There are a lot of Maxim Integrated MAX4717ETB+T Analog Switches & Multiplexers ICs applications.
- Power routing
- Battery Powered Systems
- Mechanical reed relay replacement
- SDH
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Modems
- PBXs
- MP3 players
- PDAs
- Isolation
