MAX4736ELB+T
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | WFDFN |
| Number of Pins | 10 |
| Packaging | Strip |
| Published | 2007 |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 10 |
| ECCN Code | EAR99 |
| Resistance | 800mOhm |
| Terminal Finish | GOLD |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| HTS Code | 8542.39.00.01 |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 444mW |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.4mm |
| Output | SEPARATE OUTPUT |
| Pin Count | 10 |
| Power Supplies | 1.8/3V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 3.6V |
| Min Supply Voltage | 1.6V |
| Operating Supply Current | 1μA |
| Nominal Supply Current | 1μA |
| Throw Configuration | SPDT |
| Turn On Delay Time | 30 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 25 ns |
| Off-state Isolation-Nom | 52 dB |
| On-state Resistance Match-Nom | 0.1Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-off Time-Max | 20ns |
| Height Seated (Max) | 0.8mm |
| Length | 2mm |
| Width | 2mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
MAX4736ELB+T Overview
As the electronic part is packed in WFDFN, international shipping is convenient. High reliability is achieved by using advanced packaging method Strip. Totally, there are 10 terminations. By its 1 channels, the electronic component provides high-quality output. Powered by a 3V voltage supply, the electrical part should be switched on and run. There is an electrical component included in the 10 series. An switch multiplexer with 800mOhm internal resistance has a value of 800mOhm. Please refer to the datasheets for 10 pins functions. A analogue multiplexer of this type is a Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 3.6V. A cost-effective Single supply type analogue multiplexer. There should be 1.6V voltage fed to the electrical part below 1.6V. 1μA current would be enough for this multiplexer to operate. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. During operation, the multiplexer should not be exposed to a temperature above 85°C.
MAX4736ELB+T Features
1 Channels
1μA Supply Current
MAX4736ELB+T Applications
There are a lot of Maxim Integrated MAX4736ELB+T Analog Switches & Multiplexers ICs applications.
- Fiber to the Home
- Modems
- Cable PC
- Precision instrumentation
- Sample hold systems
- Public switching systems
- High-Voltage
- Avionics and Military Systems
- Microprocessor Controlled Analog Systems
- ADCs such as AD7840/8, AD7870/1/2/4/5/6/8
