MAX4737EBE-T
| Parameters | |
|---|---|
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Base Part Number | MAX4737 |
| Pin Count | 16 |
| Operating Supply Voltage | 5V |
| Number of Channels | 1 |
| Number of Circuits | 4 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.8V |
| Operating Supply Current | 1μA |
| Nominal Supply Current | 1μA |
| Max Supply Current | 1μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 80 ns |
| Data Rate | 12 Mbps |
| Supply Type | Single |
| Turn-Off Delay Time | 40 ns |
| -3db Bandwidth | 300MHz |
| On-State Resistance (Max) | 4.5Ohm |
| High Level Output Current | 100mA |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 55 dB |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 9pF |
| On-state Resistance Match-Nom | 0.1Ohm |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 80ns, 40ns |
| Charge Injection | 5pC |
| Channel-to-Channel Matching (ΔRon) | 100m Ω |
| Crosstalk | -110dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Voltage - Supply, Single (V+) | 1.8V~5.5V |
| Normal Position | NO |
| Height Seated (Max) | 0.67mm |
| Length | 2.02mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Contact Plating | Copper, Silver, Tin |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-WFBGA, CSPBGA |
| Number of Pins | 16 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2003 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 4.5Ohm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 500mW |
| Technology | CMOS |
| Terminal Position | BOTTOM |
| Terminal Form | BALL |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 4 |
| Supply Voltage | 3V |
MAX4737EBE-T Overview
As the electronic part is packed in 16-WFBGA, CSPBGA, international shipping is convenient. High reliability is provided by advanced packaging method Tape & Reel (TR). Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have a ratio of 1:1. Operational temperature extended around -40°C~85°C TA. There are 16 terminations totally. This electronic part offers high-quality output due to its 1 channels. In the case of a voltage supply of 3V volts, the electrical part can be powered up and run. An electrical component like this is included in the 16 series. A SPST - NO switching circuit is used for these analog switches. The multiplexer consists of 4 circuits. Use MAX4737 to search for variants of the digital switches. As far as internal resistance is concerned, it has 4.5Ohm. You can find the functions of the 16 pins in the datasheets. There is Multiplexer or Switches analog multiplexer like this in the world. Users should never supply a voltage higher than 5.5V to a switch device. Single supply type digital switch with a low cost. 1.8V is the lowest voltage that should be fed to the electronic electronic part. The switch device would be able to operate with 1μA current. A voltage of 1.8V~5.5V is required to drain this analog switch from a single voltage supply. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. The electronic component can function from 5V.
MAX4737EBE-T Features
1 Channels
Switch Circuit: SPST - NO
1μA Supply Current
-3db Bandwidth: 300MHz
MAX4737EBE-T Applications
There are a lot of Maxim Integrated MAX4737EBE-T Analog Switches & Multiplexers ICs applications.
- Communication systems
- Fiber to the Home
- Communication systems
- Voice over IP/DSL – Integrated Access Devices, Smart
- Low-Voltage
- PDAs
- Industrial control systems
- Avionics test equipment
- MP3 players
- Fiber In The Loop (FITL)
