MAX4737EUD+

80ns, 40ns SPST - NO 4.5Ohm DUAL Analog Switches BREAK-BEFORE-MAKE MAX4737 14 Pins 500pA 3V 14-TSSOP (0.173, 4.40mm Width)

Manufacturer: Maxim Integrated
Nocochips NO: 503-MAX4737EUD+
Package: 14-TSSOP (0.173, 4.40mm Width)
Datasheet: PDF
Stock: 244
Description: 80ns, 40ns SPST - NO 4.5Ohm DUAL Analog Switches BREAK-BEFORE-MAKE MAX4737 14 Pins 500pA 3V 14-TSSOP (0.173, 4.40mm Width)(Kg)

Inquiry Now

Details

Tags

Parameters
Output	SEPARATE OUTPUT
Pin Count	14
Operating Supply Voltage	5V
Number of Channels	1
Number of Circuits	4
Max Supply Voltage	5.5V
Min Supply Voltage	1.8V
Operating Supply Current	1μA
Nominal Supply Current	1μA
Max Supply Current	1μA
Throw Configuration	SPST
Turn On Delay Time	100 ns
Data Rate	12 Mbps
Supply Type	Single
Bandwidth	300MHz
Turn-Off Delay Time	50 ns
On-State Resistance (Max)	4.5Ohm
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	55 dB
Current - Leakage (IS(off)) (Max)	500pA
Channel Capacitance (CS(off), CD(off))	9pF
On-state Resistance Match-Nom	0.1Ohm
Switch Circuit	SPST - NO
Switch Time (Ton, Toff) (Max)	80ns, 40ns
Charge Injection	5pC
Channel-to-Channel Matching (ΔRon)	100m Ω
Crosstalk	-110dB @ 1MHz
Switching	BREAK-BEFORE-MAKE
Switch-on Time-Max	80ns
Voltage - Supply, Single (V+)	1.8V~5.5V
Normal Position	NO
Height	950μm
Length	5.1mm
Width	4.5mm
Radiation Hardening	No
REACH SVHC	Unknown
RoHS Status	ROHS3 Compliant
Lead Free	Lead Free
Factory Lead Time	1 Week
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	14-TSSOP (0.173, 4.40mm Width)
Number of Pins	14
Operating Temperature	-40°C~85°C TA
Packaging	Tube
Published	2004
JESD-609 Code	e3
Pbfree Code	yes
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	14
ECCN Code	EAR99
Resistance	4.5Ohm
Terminal Finish	Matte Tin (Sn)
Subcategory	Multiplexer or Switches
Max Power Dissipation	500mW
Technology	CMOS
Terminal Position	DUAL
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	4
Supply Voltage	3V
Terminal Pitch	0.65mm
Time@Peak Reflow Temperature-Max (s)	30
Base Part Number	MAX4737

MAX4737EUD+ Overview

The electronic part can be shipped overseas conveniently because it is packaged in 14-TSSOP (0.173, 4.40mm Width). Advanced packaging method Tube is used to provide high reliability. Surface Mount is where this multiplexer is located. 1:1 is the ratio of multiplexer to demultiplexer circuits. The operating temperature is extended to around -40°C~85°C TA. Total terminations are 14. The electronic part provides high-quality output because it has 1 channels. When a voltage supply of 3V is used, the electronic component should be turned on and run. As part of the design of the 14 series, this electronic part has been incorporated into the system. Circuits based on SPST - NO switching are used to construct these analog switch ics. The multiplexer consists of 4 circuits. Try searching for the analog switch ic with MAX4737 if you are looking for variants. An switch multiplexer with 4.5Ohm internal resistance has a value of 4.5Ohm. Datasheets for 14 pin functions are available upon request. Multiplexer or Switches is a typical switch device. Users should never supply a voltage higher than 5.5V to a switch device. Single supply type digital switch with a low cost. In order for the electronic part to function properly, the lowest voltage should be 1.8V. For this digital switch to work, 1μA current would suffice. An analogue multiplexer drains from a single voltage supply at 1.8V~5.5V. A digital multiplexer may suffer damage if voltage is applied above 1μA. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. It can operate from 5V operating voltages. The transfer of data can be performed over 300MHz bandwidths.